Meco 6212S00T91, 6512S0DT91 Step Bowl Support & Hinge Half Assembly, Step Drip Cup Wire Assembly

11

Step 8

Bowl Support & Hinge Half Assembly

A. Attach the Bowl Supports and Flavor Activator Supports to the Bowl, orientated as shown. With the Flavor Activator Support on the inside of the Bowl and the Bowl Support on the outside, attach both Supports to the Bowl using the same pair of 1/4-20 x .59” Bolts, Fiber Washers and Nuts. The bolt and fiber washer are on the inside of the Bowl. Repeat this for the other side.

B.Attach the Bowl Hinge Halves to the Bowl, oriented with the open side up. Install two 1/4-20 x .39” Bolts with Fiber Washers through the inside of the Bowl and then the Bowl Hinge Half. Fasten in place with two Nuts. Repeat for other

hinge half.	Nut
	Bowl Hinge Half
	Fiber Washer
	1/4-20 x .39” Bolt

1/4-20 x .59” Bolt		B
with Fiber Washer	Nut	A
4 pcs

Flavor Activator

Support

1/4-20 x .39” Bolt		A
with Fiber Washer	Bowl Support
4 pcs
	Fiber Washer
1/4-20 Nut	1/4-20 x .59” Bolt
8 pc		Bowl Support

Step 9

Drip Cup Wire Assembly

Slide the Drip Cup Wire down through the small hole in the center of the bottom of the grill Bowl. (This must be done before attaching the burner.

Wire in position