Meco 6512S0DT91, 6212S00T91 manual Manual Lighting of the Grill on, Off position

26

Lighting the Grill Using the Ignitor (continued)

1.Open the Hood.

2.IMPORTANT: Make sure Control Knobs are turned “Off.” (Fig. 4)

3.Turn the LP Gas Cylinder valve open counterclockwise until it stops. (Fig. 5)

Control Knob in	Control Knob in High
	position (large flame	Fig. 5
Off position	symbol)
Fig. 4

Turn LP Gas Cylinder valve counterclockwise

Left Main Burner	Igniter Button
Control Knob
Right Main Burner	Fig. 6
Control Knob

4.Push far left Main Burner Control Knob in on Control Panel and turn counterclockwise to the High position. (Figs. 4 and 6)

5.For the model 6212, push the Piezo Igniter Button several times so that it clicks each time. Look to make sure the Burner is lit. If no spark, see Troubleshooting Section on page 33.

For the model 6512, push in and hold the electronic igniter button. Listen for the spark ignition, and look to make sure the Burner is lit. If no spark, see Troubleshooting Section on page 33.

6.From the “Off” position, light other Burner. Your grill has a Crossover Ignition System that allows the Burners to light successively off one another.

7.If the Burner fails to light, repeat Step 4-5. If it still does not light, try the right Burner.

If a Burner goes out during operation, turn all Control Knobs to the “Off” position and close the LP Gas Cylinder valve to dissipate any accumulated gas. Open Hood and wait five minutes before attempting to relight the grill.

If any or all Burners fail to light after three to four attempts following Steps 4-7, turn all Control Knobs to the “Off” position and close the LP Gas Cylinder valve to dissipate any accumulated gas. Wait five minutes; then repeat the lighting procedures.

NOTE: If the Burners still fail to light, refer to the Troubleshooting Section on page 33. The Burner can also be lit manually, see

Manual Lighting of the Grill on page 27.