Meco 6512S0DT91 Care and Maintenance, Warming Rack, End of Cooking Session, Cleaning the Grill

Page 30

30

Warming Rack

!WARNING

To reduce the risk of fire or flare-up from grease drippings:

When cooking food on the warming rack, make sure no Burners are on directly under the Drip Pan.

Clean grease drippings away from grill after each use.

Warming Racks are a convenient way to cook food, keep cooked food warm or to warm items such as bread or rolls. To keep foods warm, set the Burners on Low or turn off all that are not needed. When cooking food on the Warming Rack, follow procedures for “Roasting (Indirect Cooking).” Be sure to place a pan or drip tray under the food.

When opening the Hood, be alert of dripping fat from the Warming Rack that could drip onto the back of the grill. Always check that your Warming Rack is properly fitted before use. Wipe away any dripping grease.

End of Cooking Session

!WARNING

To reduce the risk of serious bodily injury or death from fire or burn hazard:

Allow grill and the grease in the Drip Cup to completely cool before emptying, handling parts, cleaning, moving, or storage.

Empty the Drip Cup after each cooking session so excessive grease does not accumulate.

Never light the LP gas grill without the Drip Cup in place.

1.After each cooking session, close the Hood and turn the Burners to the “High” position and burn for five minutes. This will burn off some cooking residue, thus making cleaning easier. (Side Burner not affected.)

2.When you have finished using your grill, turn the Control Knobs clockwise to the “Off” position.

3.Turn off the gas at the LP Gas Cylinder valve by turning the handle clockwise until it stops.

4.Wait until the grill is cool before closing the Hood, cleaning, or putting on a grill cover.

5.Regularly clean your LP gas grill between uses and after extended storage periods. To maintain the condition and extend the life of your grill, we strongly recommend that the unit be covered when stored outside for any length of time, especially during the winter months.

Care and Maintenance

!CAUTION

To reduce the risk of a laceration hazard, wear protective gloves when handling parts that have sharp edges.

Cleaning the Grill

Regularly clean your LP gas grill between uses and especially after extended periods of storage. Ensure the grill and its components are cool before cleaning. In order to extend the life and maintain the condition of your grill, we strongly recommend that the grill be covered when stored outside for any length of time, especially during the winter months.

Grill Cart, Bowl and Hood:

Do not mistake the accumulation of grease and smoke residue for peeling or flaking paint. Remove excess grease and/ or fat with a soft plastic or wooden scraper. Do not use steel wool or other abrasive cleaners that can scratch painted, porcelain-coated, or stainless steel surfaces. It is not necessary to remove all the grease from the body. When grill is cool, wipe it down with paper towels or soft damp cloth.

Warming Rack: Clean if necessary.

Image 30
Contents DA N G E R Tools Required for Assembly Carbon Monoxide HazardContents Preparation for AssemblyParts Illustration Model 6212S00T91 / 6512S0DT91 Parts List- Model / 6212S00T91 / 6512S0DT91 Key Description QuantityDescriptionQuantity Assembly Instructions Step Frame IdentificationStep Shroud to Leg Assembly Front Crossbrace AssemblyStep Step Tank Side Brace & Top Crossbrace Assembly Back ViewStep Crossbrace & Right Tube Brace Assembly Step Tank Locking Plate & Center Crossbrace AssemblyModel Wheel Assembly Step Bowl Support & Hinge Half Assembly Step Drip Cup Wire AssemblyStep Main Burner Assembly 6512 only Tank Heat Shield AttachmentStep Bowl to Cart Assembly Step Manifold Assembly Piezo Igniter Assembly on ModelStep Control Panel Assembly Control Panel Heat Shield Model 6512 onlyStep Main Burner Electrode Assembly Electrode Wire Plug AssemblyModel Step Side Table Assembly Step Hood Hinge Half AssemblyStep Hood Handle Assembly Step Hood/Hinge AssemblyStep Flavor Activator / Warming Rack Assembly Step Cooking Grid / Control Knob AssemblyStep Tank Blocking Wire Assembly Step Drip Cup Assembly Step Battery Installation 6512 onlyConnecting/Disconnecting the Gas Using GasLP Gas Cylinder Connecting LP Gas Cylinder Disconnecting LP Gas CylinderLP Hose and Regulator Selecting a Location Before Using Your LP Gas GrillInstallation Codes Performing a Leak TestHow to Perform a Leak Test First Time USE and as required Lighting the Grill Using the Ignitor Check The FlameManual Lighting of the Grill on Off positionManually Lighting the Grill Cooking On the Gas Grill Grill Cooking Direct MethodRoasting Indirect Method Direct Cooking on the GridsIndirect Cooking Roasting Warming Rack Care and MaintenanceCleaning the Grill End of Cooking SessionCooking Grid/Flavor Activators All Other CleaningHow to Clean the Burners BurnersStorage See Grill Cart, Bowl and Hood pTroubleshooting EmergenciesClean the Burners. See How to Clean Burners in Care MaintenanceSee How to Clean Burners in Care and Maintenance Problem Important NoticeLimited Warranty Meco Corporation Limited Warranty