Meco 6212S00T91, 6512S0DT91 manual Step Bowl to Cart Assembly

Step 11

Bowl to Cart Assembly

Place the Bowl Supports on top of the U-Frames, aligning the holes. Attach the Bowl to the cart with four 1/4-20 x .39” Bolts through the bowl Supports and into inserts in the top of the U-Frames.

1/4-20 x .39” Bolt

4 pcs

Step 12

Manifold Assembly

(and Piezo Igniter Assembly on Model 6212)

NOTE: Regulator hose is shipped attached to the Manifold. (Model 6512 has Ignition Module pre-installed)

A. Insert valve stems out through front of the Control Panel so that the holes in the valve brackets align with the holes in the Control Panel. Fasten in place with four 5/32-30 x .31” Bolts through the Control Panel into the valve brackets. The Regulator hose will be on the LEFT side.

B. (6212 only) Install the Piezo Igniter by first, removing the large nut shipped threaded in place on the igniter, then inserting the igniter through the large hole nearest the right end side of the Control Panel and then fastening in place with the large nut previously removed.

5/32-30 x .31” Bolt

4 pcs

13

A

Large Nut

B Piezo Igniter