Cleaning The Quick Set Burner Assembly
Follow these instructions to clean and/or replace parts of burner assembly or if you have trouble igniting grill.
1.Turn gas off at control knobs and LP tank.
2.Remove cooking grate and drip vaporiser bar.
3.Discard used briquets before removing burner and briquet grate.
4.Under grill remove grease cup, (unscrew ignitor button and remove battery on electronic ignition models), disconnect short ignitor wire (A) and clips from burner (B). To remove clips pull down on large end of clip attached to the valve, turn away from valve, rotate upward and remove small end of clip from burner tube.
5.Inside grill remove burner assembly and briquet grate (C), clean ceramic portion of electrode with rubbing alcohol and a swab. Remove scale from briquet grate, replace if necessary.
6.Clean outside of burner with soap and water. Lay burner upside down on flat surface, insert garden hose to force water through tubes. Make sure water comes out of all burner holes. Open clogged holes with a thin wire. Shake out excess water and examine holes. Due to normal wear and corrosion some holes may become enlarged. If any large cracks or holes are found replace burner.
7.If grill is to be stored, coat burner lightly with cooking oil. Wrap in protective cover to keep insects out.
8.If not storing grill after cleaning, hold briquet grate and burner together angle into grill bottom (D).
9.To reattach clips hold large curved end away from burner tube, insert small curved end into hole under burner tube, turn clip towards valve, snap into place.
VERY IMPORTANT: Clips must be attached correctly for proper grill function (B).
10.Reattach ignitor wire to ignitor (A). (Reinstall battery and ignitor button on electronic ignition models.)
11.Do not use more than 16 new briquets on briquet grate around burner. Do not let briquets cover burner holes.
12.Reposition drip vaporiser bar and cooking grate(s). Reattach clean can to grease clip.
13.Before cooking again on grill, follow "Burner Flame Check".
18