Cisco Systems CGS 2520 manual Removing the Power Supply Module, AC power

Chapter 3 Power Supply Installation

Removing the Power Supply Module

Note If you have a low-voltage DC power supply module, connect the wires to the terminals labeled Lo. If you have a high-voltage DC power supply module, connect the wires to the terminals labeled Hi.

Figure 3-14 Connecting the Wires to the Low-Voltage DC Power (PSU2)

Cisco CGS 25200

207428

Step 8 Torque the captive screws (above the wires) to 8.5 in-lb (± 0.5 in-lb).

Step 9 AC power

Connect the other end of the line wire (the one connected to L) to the line terminal on the AC-power source, and connect the other end of the neutral wire (the one connected to N) to the neutral terminal on the AC power source.

DC power

Connect the other end of the positive wire (the one connected to +) to the positive terminal on the DC-power source, and connect the other end of the negative wire (the one connected

to –) to the negative terminal on the DC power source.

Step 10 Close the power-input terminal cover. Use a ratcheting torque screwdriver to torque the screw to 6–8 in-lb.

Step 11 Turn on the power at the AC or DC circuit, verify that the PSU1 or PSU2 LED on the switch and PSU OK LED on the power supply module are green.

Step 12 If you have two power supplies, repeat Step 1 through Step 11. See the switch software guide for information on how to configure the power supply settings.

Removing the Power Supply Module

The power supply modules are hot-swappable. By removing the power supply modules, you can power off the switch without disconnect the wiring from the power-input terminal.

	Cisco CGS 2520 Hardware Installation Guide
OL-31444-01		3-11