Cisco Systems CGS 2520 manual Wall-Mounting, Attaching Brackets for Wall Mounting

Chapter 2 Switch Installation

Installing the Switch

Wall-Mounting

The following steps are covered in this section:

•Attaching Brackets for Wall Mounting, page 2-16

•Wall-Mounting (for IP-30 Compliance), page 2-17

Warning If the switch is wall-mounted in an enclosure allow for these minimum clearances:

•Sides of switch (facing up and facing down): 3.75 in. (9.52 cm)

•Port side 3.0 in. (7.62 cm)

•Power supply side: 5.25 in. (13.33 cm)

•Cover side (side not facing wall): 1.75 in. (4.44 cm)

•Base side (facing wall): 0 in. (0 cm)

Attaching Brackets for Wall Mounting

Follow these steps to mount the switch onto a wall.

Step 1 Insert the rubber plugs into the appropriate holes. Follow the same procedure for the other side of the switch.

Step 2 Use a screwdriver or pen to completely push in the rubber plugs (see Figure 2-8).

Step 3 Install the brackets onto both sides of the switch (see Figure 2-16).

Step 4 Secure the bracket and switch to the wall using the screws provided.

Figure 2-14shows how to wall-mount the switch onto a wall.

	Cisco CGS 2520 Hardware Installation Guide
2-16	OL-31444-01