GE Monogram Professional Outdoor Grills and Cooktop Electrical Supply Requirements

Page 10

Installation Preparation

ELECTRICAL SUPPLY REQUIREMENTS

A 120-volt, 60Hz, 15-amp power supply is required. An individual properly grounded branch circuit or circuit breaker is recommended. Install a properly grounded 3-prong electrical receptacle at the rear and below the cutout. Electrical must be located within reach of the 6-ft. power cord.

GROUNDING THE OUTDOOR COOKING CENTER AND 2-BURNER COOKTOP

IMPORTANT: PLEASE READ CAREFULLY. FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED.

The power cord of this appliance is equipped with a

3-prong (grounding) plug which mates with a standard 3-prong (grounding) wall receptacle to minimize the possibility of electric shock hazard from this appliance. Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded. Where a standard 2-prong wall outlet is encountered, it is your personal responsibility and obligation to have it replaced with a properly grounded 3-prong wall outlet.

• DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE THIRD (GROUND) PRONG FROM THE POWER CORD.

• DO NOT USE AN ADAPTER PLUG TO CONNECT THE OUTDOOR COOKING CENTER TO A 2-PRONG OUTLET.

DO NOT USE AN EXTENSION CORD WITH THIS APPLIANCE.

• DO NOT PLACE THE UNIT IN STANDING WATER OR ALLOW THE POWER CORD TO BE IMMERSED.

THIS PRODUCT IS RECOMMENDED TO

BE CONNECTED TO A POWER

SOURCE WITH GROUND FAULT

CIRCUIT INTERRUPT (GFCI)

PROTECTION WHEN INSTALLED IN AN

OUTDOOR LOCATION. FOLLOW

LOCAL CODES.

If you are uncertain about the GFCI protection on the power source to which you are connecting this appliance, please contact a professional electrician for verification.

GAS SUPPLY REQUIREMENTS

These grills are factory-set for either LP or natural gas operation.

Do not attempt to operate the cooking center on a different gas type than for what the grill orifices and regulator are set. Check the rating plate to be sure the gas supply matches the cooking product. Fuel type conversion requires a conversion kit. Contact your dealer or call 1.800.626.2002 to order.

GAS TYPE CONNECTIONS

AND CONVERSIONS

WB28X10116 – LP to Natural Gas Operation Conversion Kit . This kit is for all grill models and 2-burner cooktops. Order this kit from your Monogram supplier.

WB28X10117 – Natural to LP Gas Operation Conversion Kit . This kit is for all grill models and 2-burner cooktops. Order this kit from your Monogram supplier.

WB28X10118 – LP Portable/Stationary Conversion Kit . To change the connection from LP portable (20# tank) to whole house stationary tank or stationary tank to portable. Order this kit from your Monogram supplier.

WB28X10119 – High Altitude Conversion Kit . For operation above 2,000 feet . Order this kit from your Monogram supplier.

COOKTOP AND OUTDOOR COOKING CENTER COMBINATION INSTALLATION

Natural gas models are designed to operate at 4" water column pressure. For proper operation, the pressure of the natural gas supplied to the regulator must be between 5" and 14" water column.

LP models are designed to operate at 11" water column pressure. For proper operation, the pressure of the LP gas supplied to the regulator must be between 12" and 14" water column.

Install a manual shut-off valve in the gas line (not provided), in an easily accessible location. Make sure the homeowner knows where and how to shut off the gas supply to the grills.

10

Image 10
Contents Instructions d’installation Instrucciones de instalaciónBefore YOU Begin For Outdoor USE only Contents Design InformationBuilt-In Product Dimensions and ClearancesSide View, All Built-In Grill Models Cart with Side Burners Cart15-1/2 both sides 27 41-7/8 Accessories Accessory Product DimensionsAdvance Planning Choosing the LocationGAS Supply Requirements Power cord of this appliance is equipped with aElectrical Supply Requirements GAS Type Connections ConversionsOutdoor GRILL, Cooktop and Accessory Cutout Dimensions Grill Cutout Gas and Electrical LocationsMaterials Required not provided Tools RequiredParts Provided ZGU122 Cooktop PartsRemove Packaging from Cart Models Remove Packaging from Cart Models Blade of the appliance dollyRemove Packaging from BUILT-IN Models Cut the banding. Use a box cutter or utility knifeLP Gas Cooktop and Grill Combination Connections LP Tank TIE-DOWN for built-in island installationsLP GAS Grill Connections to a Grill or Cooktop LP gas connectionsSingle Gas Cooktop or Grill Connection LP GAS Grill Connections to a Grill or CooktopNatural GAS Grill Connections To connect 20-lb. LP tankTest for Leaks To stop a gas leakInstall Cooktop Bracket with Battery Compartment Install Bracket with Transformer Built-In Models OnlySecurity Loop Installation Instructions ZX18DS Storage Drawer ZX18TC Trash BIN