GE Monogram Professional Outdoor Grills and Cooktop instruction

Installation Instructions

ZX18DS STORAGE DRAWER

2-Drawer

18-9/16" Storage ZX18DS

17-1/4"

17"

18-3/16"

10-1/8"24-1/8"

25-3/16"

18"

1-1/4" Drawer

Overlap

2 Mounting

Screws

1-1/4" Drawer

Overlap

IMPORTANT: The supplied rear support bracket adjusts from 4-1/8"to 6-7/8". When using the supplied bracket, cut the opening at least 4-1/8"above the floor. If the opening is closer to the floor of the enclosure, use another means of support for the back of the drawer.

The rear support must be capable of supporting 50 lbs., plus load.

•Cut the opening to the dimensions shown. Reinforce the inside of the opening using at least 1" wide material surround to accept the frame-mounting screws.

NOTE: If you are installing another accessory into the same enclosure, measure and cut the openings to accommodate the bottom overlaps and align them evenly across the bottom.

•Adjust the bracket height with screws (provided) so that the drawer cabinet will be level with the cutout.

•Slide the drawers into the opening.

•Open the top drawer. Locate the screw holes in the top of the drawer cabinet, just inside the drawer. Install 2 screws (not provided) to secure the drawer to the enclosure.

Rear Support Bracket

Side View

4-1/8" to

6-7/8"