GE Monogram Professional Outdoor Grills and Cooktop Remove Packaging from BUILT-IN Models

Page 15

Installation Preparation

REMOVE PACKAGING FROM BUILT-IN MODELS

1.Cut the banding. Use a box cutter or utility knife

to score and cut the carton along the base (or remove the staples with a staple remover or a screwdriver).

2.Lift the carton straight up and off of the grill.

Cut the banding with tin snips.

Score and cut.

3.Remove all outside packing materials.

4.Remove the screws from the hold-down boards on the skid. This will allow better access to the ends when lifting the grill off the skid.

6.Close the lid. Cut the plastic tie holding the wires against the left side. Let the battery and transformer wires hang loose along the back side.

Cut tie on the rear vertical support.

7.Lift the grill off the skid and slide it into the prepared countertop opening.

8.Remove the tie holding the sear burner (on some models). Lift the wire mesh cover on the sear burner and remove packaging. Carefully, replace the wire mesh cover. The wire mesh must be wrapped around the vertical side flanges of the burner.

Lift wire mesh and

remove packaging.

Hold-Down

Boards

5. Open the lid. Cut plastic ties and bands. Remove the parts package. Remove the grill grates and packaging.

Replace wire mesh cover.

15

Image 15
Contents Instrucciones de instalación Instructions d’installationBefore YOU Begin For Outdoor USE only Design Information ContentsProduct Dimensions and Clearances Built-InSide View, All Built-In Grill Models Cart Cart with Side Burners15-1/2 both sides 27 41-7/8 Accessory Product Dimensions AccessoriesChoosing the Location Advance PlanningGAS Type Connections Conversions Power cord of this appliance is equipped with aElectrical Supply Requirements GAS Supply RequirementsGrill Cutout Gas and Electrical Locations Outdoor GRILL, Cooktop and Accessory Cutout DimensionsZGU122 Cooktop Parts Tools RequiredParts Provided Materials Required not providedRemove Packaging from Cart Models Blade of the appliance dolly Remove Packaging from Cart ModelsCut the banding. Use a box cutter or utility knife Remove Packaging from BUILT-IN ModelsLP gas connections LP Tank TIE-DOWN for built-in island installationsLP GAS Grill Connections to a Grill or Cooktop LP Gas Cooktop and Grill Combination ConnectionsTo connect 20-lb. LP tank LP GAS Grill Connections to a Grill or CooktopNatural GAS Grill Connections Single Gas Cooktop or Grill ConnectionTo stop a gas leak Test for LeaksInstall Bracket with Transformer Built-In Models Only Install Cooktop Bracket with Battery CompartmentSecurity Loop Installation Instructions ZX18DS Storage Drawer ZX18TC Trash BIN