Desa HDCFTP installation manual Check GAS Type, Installation Items, Locating Fireplace

Page 9

INSTALLATION

Continued

Note: Your Comfort Glow fireplace is designed to be used in zero clearance installations. Wall or framing material can be placed directly against any exterior surface of your fireplace, except where standoff spacers are integrally attached. If standoff spacers are attached to your fireplace, these spacers can be placed directly against wall or framing materials.

Use the dimensions shown for rough openings to create the easiest installation (see Built-In Fire- place Installation, page 10).

CHECK GAS TYPE

Use the correct gas type (natural or propane/LP) for your unit. If your gas supply is not correct, do not install fireplace. Call dealer where you bought fireplace for proper type fireplace.

WARNING: This appliance is equipped for (natural or pro- pane/LP) gas. Field conversion is not permitted.

INSTALLATION ITEMS

Before installing fireplace, make sure you have the items listed below.

external regulator - propane/LP only (supplied by installer)

piping (check local codes)

sealant (resistant to propane/LP gas)

equipment shutoff valve *

test gauge connection *

ground joint union

sediment trap

tee joint

pipe wrench

*A CSA design-certified equipment shutoff valve with 1/8" NPT tap is an acceptable alternative to test gauge connection. Purchase the optional CSA design-certified equipment shutoff valve from your dealer. See Accessories, page 30.

Note: If desired, purchase a four-sided brass trim kit for built-in installations. See Accessories, page 30.

LOCATING FIREPLACE

WARNING: Maintain the minimum clearances shown in Figures 7 and 8. If you can, provide greater clearances from floor, ceiling, and joining wall.

You can recess firebox into the wall. You can also position fireplace in the optional cabinet or corner mantels. IMPORTANT: Only use optional cabinet or corner mantels specified in this manual. Purchase the optional mantel from your dealer (see Accessories, page 30).

WARNING: Never install the fireplace

in a bedroom or a bathroom

in a recreational vehicle

wherecurtains,furniture,clothing, or other flammable objects are less than 36 inches from the front, top, or sides of the fireplace

as a fireplace insert

in high traffic areas

in windy or drafty areas

CEILING

 

36" Minimum

6"

 

Minimum

 

From

 

Sides Of

 

Fireplace

 

Left

Right

Side

Side

FLOOR

Figure 7 - Mounting Clearances As

Viewed From Front of Fireplace Shown

Built In The Wall

CEILING

36"

Top OfMinimum Mantel Can

Be Flush

With Wall

 

Right

Left

Side

 

Side

 

Figure 8 - Mounting Clearances As

Viewed From Front of Fireplace Shown

with Optional Mantel

111044-01E

www.desatech.com

9

Image 9
Contents Shown with Optional Cabinet Mantel/Hearth Base Accessory HDCFTP, HDCFTN, Cgcftp and Cgcftn14,000 to 26,000 Btu/Hr with Thermostat Table of Contents Safety Information Local Codes Product InformationProvide adequate clearances around air openings Product Features AssemblyUnpacking Assembling Hood Providing Adequate VentilationDetermining FRESH-AIR Flow for Heater Location AIR for Combustion VentilationConfined and Unconfined Space Determining if You Have a Confined or Unconfined SpaceVentilation AIR InstallationVentilation Air From Inside Building Ventilation Air From OutdoorsInstallation Items Check GAS TypeLocating Fireplace Rough Opening for Installing Wall BUILT-IN Fireplace InstallationAttaching Fireplace to Wall Studs If you have not assembled firebox, follow instructions onOptional Mantel Installation Mantel Clearances for BUILT- in InstallationRemoving Upper Louver Assembly Installing Blower AccessoryRemoving Valve Cover Shield Removing Valve Cover ShieldFor Built-In Installation Installing Switch Plate to Valve Cover ShieldConnecting to GAS Supply Attaching Wood Base to Solid FloorExtension Cord Installation Items Needed Connecting Equipment Shutoff Valve to Heater ControlChecking GAS Connections Test Pressures In Excess Of 1/2 Psig 3.5 kPaTest Pressures Equal To or Less Than 1/2 Psig 3.5 kPa Read Before Lighting For Your SafetyEquipment Shutoff Valve Propane/LPLighting Instructions Operating FireplaceTo Turn OFF GAS To Appliance Shutting Off FireplaceInspecting Burner Manual Lighting ProcedureThermostat Control Operation Burner Flame PatternBurner Injector Holder and Pilot AIR Inlet Hole Cleaning MaintenanceCabinet Air PassagewaysObserved Problem Possible Cause Remedy TroubleshootingDelayed ignition of burner Manifold pressure is too low Out when control knob is reODS/pilot lights but flame goes Press in control knob fullyWalls or furniture Cleaners, etc. may turn into Burner orifice Clean burner see CleaningGas regulator defective Nance, Replace gas regulator Air in gas line Minute Operate burner until air isGas leak. See Warning Replacement Parts SpecificationsService Hints Technical ServiceModels Cgcftp and Cgcftn Illustrated Parts BreakdownPart Number KEY Hdcftp Hdcftn Cgcftp Cgcftn Description QTY Parts ListAccessories FBD Parts CentralsWarranty Information Keep this WarrantyLimited Warranty VENT-FREE Compact Fireplace