INSTALLATION
Continued
Pressure Testing Fireplace Gas Connections
1.Open equipment shutoff valve (see Figure 23, page 16).
2.Open main gas valve located on or near gas meter for natural gas or open propane/LP supply tank valve.
3.Make sure control knob of fireplace is in the OFF position.
4.Check all joints from equipment shutoff valve to gas control valve (see Figures 24 or 25, page 16). Apply noncorrosive leak detection fluid to all joints. Bubbles forming show a leak.
5.Correct all leaks at once.
6.Light fireplace (see Operating Fireplace, page 20.) Check all other internal joints for leaks.
7.Turn off fireplace (see To Turn Off Gas to Appliance, page 21).
INSTALLING LOGS
CAUTION: Do not remove the dataplatesattachedtotheheater base assembly. The data plates contain important warranty and safety information.
WARNING: Failure to posi- tion the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
WARNING: After installa- tion and periodically thereafter, check to ensure that no flame comes in contact with any log. WiththeheatersettoHigh,check to see if flame contact any log. If so, reposition logs according to the log installation instructions in this manual. Flames contact- ing logs will create soot.
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
Models LMFP33PR and LMFP33NR
1.Place pins in rear log (#1) into holes on rear of base grate as shown in Figure 26.
2.Place middle log (#2) between front and rear of burner. The left side will rest on the left tab and the right will straddle the burner as shown in Figure 26.
3.Place front log (#3) onto grate fingers at front of base grate (see Figure 27). Make sure log seats well into grate.
4.Place left top log on left pins on logs #2 and #3, resting it on log #1( see Figure 28, page 18).
5.Place right top log on right pins on logs #2 and #3 (see Figure 28, page 18).
Middle
Log (#2)
Rear Log (#1)
Figure 26 - Installing Rear and Middle
Logs
Front Log (#3)
Figure 27 - Installing Front Log
www.desatech.com | 17 |