Desa LMFP33PR(A) Installing Batteries in Receiver, Installing Battery into Remote

Page 19

INSTALLATION

Continued

INSTALLING BATTERIES FOR REMOTE RECEIVER AND HAND HELD REMOTE CONTROL

Four AA batteries and three AAA batteries are required to operate this heater with the wireless hand-held remote control set. Four AA batteries must be installed in the receiver and three AAA batteries in the hand-held remote control unit.

Note: Only use alkaline batteries.

Installing Batteries in Receiver

1.Locate slot on battery cover of receiver (see Figure 33). Firmly insert tool such as a small screwdriver, butter knife or dime into the slot and lift up to remove cover.

2.Insert 4 AA batteries into receiver. Positive and negative are marked inside receiver casing. Note: Receiver will not function if batteries are not installed correctly.

3.Slide tab on cover into receiver housing and snap cover back into place.

Installing Battery into Remote

1.Remove remote cover (see Figure 34).

2.Insert 3 AAA batteries into remote control (see Figure 34). Positive and negative are marked inside remote control casing. Note: Remote will not function if batteries are not installed correctly.

3.Slide remote cover back into place.

3 AAA Batteries

Cover

Remote

Control

Figure 34 - Installing Batteries in Remote Control

4 AA Batteries

Battery

Housing

Slot Cover

Receiver Backup Switch

Figure 33 - Installing Batteries in

Receiver

111604-01L

www.desatech.com

19

Image 19

Contents What to do if YOU Smell GAS Table of Contents Safety Information Product Identification Log Base AssemblyAIR for Combustion Ventilation Product FeaturesLocal Codes UnpackingConﬁned and Unconﬁned Space Providing Adequate VentilationDetermining FRESH-AIR Flow for Fireplace Location Unusually Tight ConstructionVentilation Air From Inside Building Ventilation AIRVentilation Air From Outdoors Check GAS Type InstallationElectrical Hookup Example Installing HoodInstalling Cabinet Mantel Conventional Fireplace InstallationInserting Fireplace Into Cabinet Mantel BUILT-IN Fireplace InstallationInstalling Shield to Support Mantel Clearances for Built-In InstallationInstallation Items Needed Installing GAS Piping to Fireplace LocationPropane/LP Natural GasRemoving Log Base Assembly From Fireplace Connecting Fireplace to GAS SupplyTest Pressures Equal To or Less Than 1/2 Psig 3.5 kPa Checking GAS ConnectionsTest Pressures In Excess Of 1/2 Psig 3.5 kPa Pressure Testing Fireplace Gas Connections Installing LogsModels LMFP33PR and LMFP33NR Middle Models LMFP33PRA and LMFP33NRAInstalling Battery into Remote Installing Batteries in ReceiverOperating Heater For Your Safety Read Before LightingLighting Instructions Manual Lighting ProcedureTo Turn OFF GAS To ApplianceHAND-HELD Remote Operation Main Burner Inspecting BurnersPilot Flame Pattern Burner Primary AIR HolesPilot AIR Inlet Hole Burner Injector HolderLogs Observed Problem Possible Cause Remedy TroubleshootingDiagram, See Cleaning and Mainte Statement above Gas leak. See WarningReplacement Parts SpecificationsWiring Diagram Service Hints Technical ServiceModels LMFP33PR, LMFP33PRA, LMFP33NR and LMFP33NRA Shown Illustrated Parts BreakdownParts List Firebox LMFP33PR, LMFP33PRA, LMFP33NR and LMFP33NRA KEY Part Number Description QTY Information Video AccessoriesBlower Accessory GA3750A and GA3650TB Series Equipment Shutoff Valve GA5010111604-01L Keep this Warranty Warranty InformationLimited Warranty VENT-FREE GAS Fireplace