Desa VTGF33NRB, VTGF33PRB Operating Fireplace, Installing Battery Into Remote, Installing Screen

Page 21

INSTALLATION

Continued

INSTALLING BATTERY INTO REMOTE

1.Locate slot at bottom of remote control (see Figure 35). Firmly insert tool such as a small screwdriver, butter knife, or dime into the slot and lift up to remove cover.

2.Insert supplied battery into remote control. Positive and negative are marked inside re- mote control casing. Note: Remote will not function if battery is not installed correctly.

3.Slide tab on cover into remote housing and snap cover back into place.

IMPORTANT: Use only A23 12 volt battery in remote. DO NOT use AAA battery.

Tab

SlotCover

A23 12

 

Volt

 

Battery

 

Positive

 

 

Remote

Negative

Control

 

Figure 35 - Installing Battery

INSTALLING SCREEN

Install fireplace screen by slipping notches of fireplace screen over screws on front of fireplace (see Figure 36).

Screws for

Mounting

Screen

Notches

Figure 36 - Installing Fireplace Screen

OPERATING FIREPLACE

FOR YOUR SAFETY

READ BEFORE LIGHTING

WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result causing property damage, per- sonal injury or loss of life.

A.This appliance has a pilot which lights automatically when using the supplied wall switch or remote control. If you have a power outage, the pilot may be lighted by hand with push-button piezo ignitor. When lighting the pilot, the following warnings must be followed.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electric switch; do not use any phone in your building.

Immediately call your gas supplier from a neighborʼs phone. Follow the gas supplierʼs instructions.

If you cannot reach your gas supplier, call the fire department.

C.Electric Power Outage Only: Use only your hand to turn the manual override handle on the gas control knob. Never use tools. If the knob will not turn by hand, donʼt try to repair it, call a qualified ser- vice technician or gas supplier. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which

113134-01B

www.desatech.com

21

Image 21
Contents What to do if YOU Smell GAS Table of Contents Safety Information Product Identification Local Codes Product FeaturesUnpacking AIR for Combustion VentilationDetermining FRESH-AIR Flow for Heater Location Providing Adequate VentilationUnusually Tight Construction Confined Space and Unconfined SpaceVentilation AIR Ventilation Air From Inside BuildingVentilation Air From Outdoors Installation Clearances InstallationCheck GAS Type Electrical HookupInstallation Sequence Removing Fireplace Screen and Floor AssemblyMinimum 16 inches from Side Wall Relocating Wall Switch Assembly Electrical Connections for Power CordFor Mantel Installation For Recessed InstallationMounting Wall Switch Assembly to Wall for Recessed Fireplace Remove wall switch assembly from bracketMounting Wall Switch Assembly to Side of Mantel Opening in Wall or Mantel Wall Wall Switch Assembly ScrewsInstallation Items Needed Installing GAS Piping to Fireplace LocationAssembly, Connecting Fireplace to GAS SupplyNatural Check all gas connections for leaks. SeeChecking GAS Connections Test Pressures Equal To or Less Than 1/2 Psig 3.5 kPaTest Pressures In Excess Of 1/2 Psig 3.5 kPa Break off nailing flanges see with hammer or pliers Conventional Fireplace InstallationInserting Fireplace Into Cabinet Mantel BUILT-IN Fireplace InstallationAttaching Fireplace to Wall Studs Assembling Perimeter Trim Installing HoodInstalling Log #2 Right Log #3 Left Installing LogsInstalling Screen Installing Battery Into RemoteFor Your Safety Read Before Lighting Operating FireplaceUsing Supplied Wall Switch Assembly Using Hand-Held Wireless Remote ControlNormal Lighting Instructions Shutting Off Heater Wall Switch Manual Lighting Instructions for Electrical Power OutageShutting Off Heater Wireless Remote Control To Turn OFF GAS To ApplianceOptional Blower Operation Inspecting BurnersOperating FAN Pilot Flame PatternYou could damage the pilot assembly Inspected yearly by a qualified service personBurner Flame Patterns Burner Injector HoldersCleaning Maintenance SpecificationsLogs Observed Problem Possible Cause Remedy TroubleshootingGas regulator defective Nance, Replace regulator Not enough air Check burner for dirt OperationOn windows Tilation air Turning control knob toProblem could be caused by Clean ODS/pilot seeAssembly EnoughStatement above Gas leak. See WarningService Hints Replacement PartsTechnical Service Parts Under WarrantyIllustrated Parts Breakdown KEY Part Number Description QTY Parts ListFireplace Models VTGF33NRB and VTGF33PRB 100639-01 104356-02 Not a field replacement part Accessories Cabinet Mantel and Full Hearth Base Laminate Trim for Hearth or MantelFire Crackle CF6-A Extruded Louver KIT Receiver and HAND-HELD Thermostat Remote Control KIT Ghrctb Receiver and HAND-HELD Remote Control KIT GhrcbFirebox Brick Liner G8005 Diameter Holes Diameter 2 Holes TemplatesThis page Intentionally Left Blank Wiring Diagram 113134-01B 113134-01B Warranty Information Keep this WarrantyLimited Warranty VENT-FREE GAS Fireplace

VTGF33NRB, VTGF33PRB specifications

Desa VTGF33PRB and VTGF33NRB are advanced heating solutions that combine innovative technology and design for optimal performance and user convenience. These models are well-suited for residential and commercial applications, providing efficient heating while enhancing the overall aesthetic of any space.

One of the main features of the VTGF33PRB and VTGF33NRB is their high-efficiency ratings, which allow them to deliver effective heating with minimal energy consumption. This efficiency not only helps users save on energy bills, but it also makes these models environmentally friendly, aligning with modern sustainability goals.

Both models utilize advanced infrared heating technology, which generates heat by directly warming objects and people in the room rather than heating the air. This results in a more comfortable and even distribution of warmth, providing immediate relief from cold temperatures. The infrared heating method is particularly beneficial in large or drafty spaces, as it can significantly reduce heating times and energy usage.

In terms of design, the VTGF33PRB features a sleek, modern appearance that can easily complement any décor. Its robust construction ensures durability, making it suitable for long-term usage. The VTGF33NRB, on the other hand, offers a more traditional aesthetic, perfect for those who prefer classic designs. Both models are user-friendly, designed with intuitive controls that allow for easy operation and temperature adjustments.

Another noteworthy characteristic of the Desa VTGF33 series is their safety features. Each unit is equipped with advanced safety mechanisms, including tip-over protection, overheat shut-off, and a sturdy base to prevent accidents. These safety features provide peace of mind for users, especially in households with children or pets.

The VTGF33PRB and VTGF33NRB also incorporate quiet operation technology, ensuring that heating is achieved without disruptive noise. This makes them ideal for use in bedrooms, offices, or any space where tranquility is desired.

Overall, the Desa VTGF33PRB and VTGF33NRB are exemplary models that showcase the harmonious blend of efficiency, safety, and design. Their advanced features and technologies make them reliable choices for anyone looking to enhance their heating solutions while maintaining comfort and style. With their commitment to quality and innovation, Desa continues to lead the way in the heating industry.