Desa Tech CGEFP33PR Installing Hood, Mantel Clearances for Built-In Installation

UNVENTED PROPANE/LP GAS FIREPLACE

INSTALLATION

Continued

Mantel Clearances for Built-In Installation

If placing mantel above built-in fireplace, you must meet minimum clearance between mantel shelf and top of fireplace opening.

6.	While firmly holding edges of brass trim
	together, tighten both set screws on the
	adjusting plate with slotted screwdriver.
7.	Repeat steps 1 through 6 for other side.
8.	Tighten trim hanging screws (#10 x
	6.25 shoulder) into holes in cabinets.
	Place the assembled trim onto fireplace
	cabinet. Align hanging notches on trim
	with hanging screws on side of fire-
	place (see Figure 38). Push trim firmly

Wall board or facing material (above firebox) may be of combustible material, including decorative

Mantel Shelf

into place, sliding hanging notches over

hanging screws.

Side Set Screws Top

mantel ornaments or other similar projec- tions off of the facing material.

Framing

Material

8"

6"

21/2"

Brass	Brass
Trim	Trim
	Adjusting
	Plate

Firebox

Noncombustible Material May Project Off this Surface above the Firebox Hood

13" 16" 19" 21"

Note: All vertical

Slot

Shim

Slot

Mitered Edge

Wire-mesh Screen

Supplied Firebox

Hood Must Be

Used at All Times

measurements are from top of fireplace hood opening to bottom of mantel shelf.

These minimum clearances replace any other recommended clearances supplied with your ANS Z21.11.2 approved gas logs.

Figure 37 - Assembling Brass Trim

Trim

Hanging

Screws

Figure 36 - Minimum Mantel Clearances for Built-In Installation

Hanging Notches

NOTICE: Surface temperatures of adjacent walls and mantels be- come hot during operation. Walls and mantels above the firebox may become hot to the touch. If installed properly, these tempera- tures meet the requirement of the national product standard. Fol- low all minimum clearances shown in this manual.

NOTICE: If your installation does not meet the minimum clearances shown, you must do one of the following:

•raise the mantel to an accept- able height

•remove the mantel

ASSEMBLING AND ATTACHING OPTIONAL BRASS TRIM (Included with Mantel Accessory)

INote: The instructions below show assem- bling and attaching brass trim to fireplace.

1.Remove packaging from three pieces of brass trim.

2.Locate four brass screws, two adjust- ing plates with set screws, and two shims in the hardware packet.

3.Align shim under adjusting plate as shown in Figure 37.

4.Slide one end of adjusting plate/shim in slot on mitered edge of top brass trim (see Figure 37).

5.Slide other end of adjusting plate/shim in slot on mitered edge of side brass trim (see Figure 37).

on Trim

Assembled

Brass Trim

Figure 38 - Attaching Brass Trim to Fireplace

INSTALLING HOOD

Install hood to top of firebox as shown in Figure 39. Use 3 Phillips screws provided.

Figure 39 - Installing Hood to Firebox

For more information, visit www.desatech.com 18 107570