Desa Tech CGEFP33PR installation manual Product Identification, Local Codes, Unpacking

Page 3

OWNER’S MANUAL

SAFETY

INFORMATION

Continued

16.Operating fireplace above elevations of 4,500 feet could cause pilot outage.

17.To prevent performance problems, do not use propane/LP fuel tanks of less than 100 lbs. capacity.

PRODUCT

IDENTIFICATION

Log Set

Manual Override

 

 

 

Handle

 

 

 

Remote

Piezo

 

 

Control

Wall

 

Ignitor

Manual Ignition

 

 

 

Switch/

Bypass Switch

 

 

Plate

 

Figure 1 - Fireplace Floor Assembly (EFP33PR Shown)

Top Outer Casing

Top Louver

Assembly

Firebox Hood

Firebox Support

Screen

 

 

Assembly

 

 

 

Bottom

Blower Assembly

 

Louver

(Optional)

Figure 2 - Fireplace

Assembly

 

 

 

LOCAL CODES

Install and use fireplace with care. Follow all local codes. In the absence of local codes, use the latest edition of The National Fuel Gas Code, ANS Z223.1, also known as NFPA 54*.

*Available from:

American National Standards Institute, Inc.

1430 Broadway

New York, NY 10018

National Fire Protection Association, Inc.

Batterymarch Park

Quincy, MA 02269

UNPACKING

1.With utility knife, cut the carton all the way around above the staples on the bottom tray. Lift the carton off the heater. Remove packing. Note: The hood is located in the packing on the right hand side of the fireplace. Lift the fireplace off the bottom tray.

2.Locate two screws above top corners of the fireplace screen. Remove and discard these screws. Lift fireplace screen up and pull out to remove.

3.Remove protective packaging applied to logs, fireplace floor assembly, and fireplace.

4.Check all items for any shipping dam- age. If damaged, promptly inform dealer where you bought fireplace.

107570

3

For more information, visit www.desatech.com

Image 3
Contents What to do if YOU Smell GAS OWNER’S Operation and Installation ManualUnvented PROPANE/LP GAS Fireplace Safety InformationProduct Identification Local CodesUnpacking AIR for Combustion and Ventilation Product FeaturesAIR for Combustion Ventilation Determining FRESH-AIR Flow for Fireplace LocationDetermining if You Have a Confined or Unconfined Space Ventilation Air From Outdoors Ventilation AIRVentilation Air From Inside BuildingElectrical Hookup InstallationInstallation Clearances Check GAS TypeInstallation Sequence Removal of Fireplace Screen and Floor AssemblyRelocating Wall Switch Lines and wiring when moving floor Mounting Wall Switch to Side of Mantel Installing Variable Speed Blower AccessoryOperating the Blower Installing Plastic Bushing for Power CordLower Rear Wall Firebox Blower Installing Thermostatic Blower AccessoryInstalling Bushings Left Side Exit shown Installation Items Needed Installing GAS Piping to Fireplace LocationChecking GAS Connections Connecting Fireplace to GAS SupplyPressure Testing Gas Supply Piping System Pressure Testing Fireplace Gas ConnectionsChecking Gas Joints Conventional Fireplace InstallationInserting Fireplace Into Cabinet Mantel BUILT-IN Fireplace InstallationMantel Clearances for Built-In Installation Installing HoodInstalling Logs EFP33PR Installing Logs CGEFP33PRInstalling Battery Into Remote Installing ScreenOperating Fireplace For Your Safety Read Before LightingUsing Supplied Wall Switch Using Hand-Held Wireless Remote ControlManual Lighting Instructions For Electrical Power Outage To Turn OFF GAS To ApplianceOptional Blower Operation Inspecting Burners Cleaning and MaintenanceObserved Problem Possible Cause TroubleshootingObserved Problem Possible Cause Remedy Gas leak. See Warning statement Wiring Diagram Technical Service SpecificationsReplacement Parts Service HintsParts Dealers Illustrated Parts Breakdown Remote Control Fireplace EFP33PR and CGEFP33PR Parts ListFirebox KEY Part Number Description QTY Equipment Shutoff Valve GA5010 AccessoriesBlower Accessory GA3750 Series and GA3650T Series Corner MantelDiameter Holes This page Intentionally Left Blank 107570 Warranty Information