OWNER’S MANUAL
INSTALLATION
Continued
INSTALLING LOGS (CGEFP33PR)
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
CAUTION: After installation and periodically thereafter, check to ensure that no flame comes in contact with any log. With the heater set to HIGH, check to see if flames contact any log. If so, reposition logs according to the log installation instructions in this manual. Flames contacting logs will create soot.
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
1.Locate pegs on the bottom of back log (#1). Slide these pegs into the holes in the grate base behind the burner (see Figure 40).
Back
Log (#1)
Hole in
Grate Base
Burner
Figure 40 - Installing Back Log (#1)
2.Place the base of the middle log (#2) in the
3.Locate the recesses on the back of the front log (#3). Fit these recesses between the posts of the grate base (see Figure 42).
4.Locate the notches in the bottom of the crossover log (#4). Place the crossover log on top of the middle log and front log. Make sure the notches of the crossover log lines up with rectangular knobs on top of the middle and front logs (see Figure 43).
Middle Log (#2)
Tab
Cutout
Burner
“U” Bend
Slot
Figure 41 - Installing Middle Log (#2)
Front Log (#3)
Recess
Post
Post
Figure 42 - Installing Front Log (#3)
Crossover
Log (#4)
Rectangular
Knobs
Figure 43 - Installing Crossover Log (#4)
INSTALLING LOGS (EFP33PR)
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
CAUTION: Do not remove the warning and instruction labels attached to the heater base as- sembly. These markings contain important warranty information.
WARNING: After installation and periodically thereafter, check to ensure that no flame comes in contact with any log. With the heater set to High, check to see if flames contact any log. If so, re- position logs according to the log installation instructions in this manual. Flames contacting logs will create soot.
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
Continued
107570 | 19 | For more information, visit www.desatech.com |