UNVENTED PROPANE/LP GAS FIREPLACE
INSTALLATION
Continued
INSTALLATION SEQUENCE
After unpacking fireplace (see UNPACK- ING, page 3), we suggest that you install your fireplace system in the following sequence:
1.Removal of fireplace floor assembly (required)
2.Electrical connections for power cord (required)
3.Relocating wall switch (optional)
4.Installing blower accessory (optional)
5.Connecting fireplace to gas supply (required)
6.Checking gas connections (required)
7.Firebox installation, conventional or
8.Installing brass perimeter trim (op- tional)
9.Installing fireplace hood (required)
10.Installing logs (required)
11.Installing fireplace screen (required)
Use the following instructions to complete each step.
REMOVAL OF FIREPLACE SCREEN AND FLOOR ASSEMBLY
NOTICE:
1.Remove fireplace screen. Remove two screws that hold fireplace screen in place for shipping. These screws are located near top of screen. Discard screws. Lift fireplace screen up and pull out to remove.
2.If logs are installed, carefully remove the logs and set aside, noting the prop- erly mounted location of each.
3.Remove screws that attach fireplace floor assembly to fireplace. Open lower louver door. Carefully lift up fireplace floor assembly and remove from fireplace, taking care to pull flex- ible gas line through the access holes (see Figure 6). Note: Be careful of all wires on underside of log base.
CAUTION: Do not pick up fire- place floor assembly by burners. This could damage burners. Only handle base by grates.
Flexible Gas Line
Screws | Fireplace Floor |
| |
| Assembly |
Figure 6 - Removing Fireplace Floor Assemlby
ELECTRICAL CONNECTIONS FOR POWER CORD
This fireplace operates on 120 VAC, 60 Hz power. An electrical power cord is supplied with this unit.
For Mantel Installation
1.Determine from which side of the fire- place the power cord will exit. Locate the 1.5" diameter hole near the center of floor support bracket on appropriate side of lower cavity (see Figure 7).
2.Locate power cord. Remove wire tie or tape holding plug end of power cord.
3.Power cord has 2 plastic hole bushings threaded onto it. Route cord's
4.Push first plastic bushing completely through hole. Squeeze bushing as needed to do this.
5.Install the second plastic bushing into the hole in the floor support bracket by snapping into place.
6.Route the
7.Install the first plastic bushing into this hole by snapping into place.
8.After you have connected to gas supply and checked your gas connections (see pages 14 and 15), plug power cord into any convenient
Hole in Floor | Hole | in Outer |
Support Bracket | Casing | |
Bushings 
Power
Cord
Figure 7 - Routing Power Cord
For Recessed Installation
If an outlet is not installed in fireplace, install model GA3555 - Outlet Kit with Cover. This kit will supply a convenient 3- prong grounded electrical outlet for power. Refer to installation manual provided with this optional accessory for instructions on wiring. Note: A qualified installer must make all electrical connections.
RELOCATING WALL SWITCH
Note: The decorative wall switch plate sup- plied is white. The wall switch plate may be painted to match your decor.
The
Note: If you choose to relocate the wall switch, do so before final installation into a mantel or recessing into a wall. If you are installing an optional blower accessory, in- stall it at the same time you relocate the wall switch.
For more information, visit www.desatech.com | 8 | 107570 |