Hearth and Home Technologies 36, 42 owner manual Operating Instructions, General Information

Page 25

9Operating Instructions

WARNING

Fire Risk

Do not operate fireplace before reading and understanding operating instructions.

Failure to operate fi replace properly may cause fi re.

A. General Information

Fireplaces, as well as other woodburning appliances, have been used safely for many years. It has been our experience that most problems are caused by improper installation and operation of the fi replace. Make certain that installation and operation of the fi replace system is in accordance with these instructions.

It is extremely important that the fi re be supervised when- ever the fi replace is in use. It is also recommended that an annual inspection be performed on the fi replace system to determine if the fl ue system needs to be cleaned, or as in the case of any appliance, if minor repairs are required to maintain the system in top operating condition.

WARNING

HOT SURFACES!

Glass and other surfaces are hot during operation and cool down.

Hot glass will cause burns.

• Do not touch glass until it is cooled

NEVER allow children to touch glass

Keep children away

CAREFULLY SUPERVISE children in same room as appliance.

Alert children and adults to hazards of high temperatures.

High temperatures may ignite clothing or other flammable materials.

Keep clothing, furniture, draperies and other combustibles away.

WARNING

Fire Risk

For use with solid wood fuel or decorative gas appliance only.

Do not install unvented gas logs.

Damper

Figure 9.1 General Operating Parts

Outdoor Lifestyles by Hearth & Home Technologies Inc. • Montana US-CAN4039-156 Rev K • 7/11

25

Image 25
Contents Fire Risk Hot glass will cause burnsSerial Number Grate Listing Label Information/LocationModel Table of Contents Appliance Certification Listing and Code ApprovalsNot intended for use as a primary heat source Getting Started Design and Installation ConsiderationsMoisture Resistance Typical Fireplace SystemInspect Fireplace and Components Tools and Supplies NeededFire Risk Explosion Risk Framing and Clearances Freestanding Installations see FigureSelecting Fireplace Location Exterior Walls see FigureEnclosed Fireplace Clearances to Combustible Materials ClearancesFrame the Fireplace Sidewalls/SurroundsChimney Requirements Install the Dual Cooling Air Kit Installation of FireplaceSharp Edges Asphyxiation Risk Position the Fireplace Secure the FireplaceHeight of Chimney Components Chimney AssemblyChimney Offset/Return Using Offsets/ReturnsAssemble the Chimney Sections Install the Ceiling FirestopsDouble-check the Chimney Assembly Install the Attic Insulation ShieldSecure the Chimney  in./19 mm in lengthChimney Termination Complete the EnclosureMark the Exit Point of the Roof Chase TopST1175/ST475 Square Termination Cap Install the Termination CapTCT1175 Terra Cotta Cap Gas Log/Lighter Provisions AccessoriesGas Code, Ansi Z223.1 Hearth Extension FinishingMantel Finishing MaterialGlass Doors General Information Operating InstructionsClear Space Near the Fireplace Outside AirFlue Damper FirescreenWood Fuel GrateStarting a Fire Diagnostics and Problem Solving TroubleshootingChimney Inspection/Cleaning Maintenance and Servicing the FireplaceDisposal of Ashes Firebox RefractoryWhen cleaning glass door Maintenance Task ListClean Chimney FireReference Materials Fireplace DimensionsDescription Fireplace ComponentsCatalog # Chimney ComponentsAssembled Diameter 17 in./432 mm Height 24 in./610 mm 15-3/4 400 mm 635 x 635 mm 584 x 584 mm 737 x 737 mm Woodburning Termination CapMONTANA-36, MONTANA-36H D. Service PartsMONTANA-42, MONTANA-42H Service PartsThis page intentionally left blank This page intentionally left blank Warranty Coverage This warranty is void if Limited WarrantyRO N a CO ISD D