Sears 125.15884800 owner manual Assembly, Step

Leg with Hole

Bolt Holes

Support Tabs

ASSEMBLY

Choose a good, cleared assembly area and get a friend to help you put your smoker together. Lay cardboard down to protect smoker finish and assembly area.

CAUTION: Some parts may contain sharp edges. Wear protective gloves if necessary.

Note: With the help of a friend, turn the smoker cabinet upside down.

Step 1

For each leg, line up the holes of cabinet and insert the 1/4-20 X 5/8” bolts; nuts are pre-welded to the cabinet. Securely tighten the bolts. Make note of the arrow in the illustration. This is where the leg with the hole in it should be installed. DO NOT yet insert the two bolts in the locations indicated by the circles.

Step 2

Place the Control Panel Assembly between the front legs as shown. There is a slot on each side of the control panel that fits around the edge of the leg. The two mounting tabs fit to the inside of the legs and line up with the bolt holes. Be sure both the support tabs on the back side of the control panel are captured behind the legs as shown to the right.

Step 3

Insert the two remaining 1/4-20 X 5/8” bolts through the mounting tabs and tighten them securely.