Kenmore 141.1686 Assembling The LP Gas Tank Hook, Assembling The Grill Pulled-out Spice Tray

Assembling The LP Gas Tank Hook

Attach the Pressure Cylinder Holder and Tank Guide to the Cart Legs-Wheel Side of grill as shown in Fig. 6. Align the tapped holes of both parts with the holes on Side Panel. Secure firmly using 4 of the 1/4"x1/2" Phillips head screws and nuts provided.

Assembling The Grill Pulled-out Spice Tray

1.Install 2 of the 1/4"x1/2" Phillips head screws to the rear of the Track. Without these screws

the Pulled-out Spice Tray will not stop properly.

2.Slide the Pulled-out Spice Tray into the Tracks until it stops. See Fig. 7.

. Install 2 of the 1/4"xl/2" Phillips head screws to the front of the Track. This important step prevents the Pulled-out Spice Tray from being pulled outside the tracks. See Fig. 7.

Installing The Grill Head

Now that you've assembled the grill cart you can install the pre-assembled Grill Head. See Fig. 8. To reduce the weight of the Grill Head, we suggest you open the Grill Lid and remove the packed components. Even with the components removed, this step requires 2 people to lift and position the Grill Head onto the grill cart. Be sure to align the 2 holes beneath the hang ledge on each side of the Grill Head with the 2 holes on each cross brace of cart. Raise Grill Lid and insert 4 of the 1/4"xl-3/8" Phillips head screws and lock nuts and tighten securely.

2.From the back side of grill head, install the Grease Draining Tray. See Fig. 8.

3.Center the Grease Receptacle under Grease Draining Tray. See Fig. 8.

. Install Rear Wind Shield between both Bowl Side Panels by using 2 of the 1/4"x1/2"

Phillips head screws provided. See drawing below.

Figure 6

FOR PULLED-OUT

SPICE TRAY

PRESSURE

CYLINDER

HOLDER

PULLED-OUT

SPICE TRAY

TANK GUIDE

Figure 7

FOR PULLED-OUT

SPICE TRAY

PULLED-OUT

SPICE TRAY

Figure 8

GREASEGREASE

GRILL HEADDRAININGRECEPTACLE

2

II

I !

I I I

HANG LEDGE

CROSSBRACE

11