Step 4
Install side burner locks
Note: The locks are taped to the inside of the side burner lid.
You will need: frame assembly, two side burner locks and a 7/16 inch wrench.
Turn frame assembly right side up.
Loosen the right rear 1/4 x 20 bolt. Install the side burner lock. The “U” shape cut out of the lock slips down over the bolt. Tighten with a wrench. Figure 3 (a).
Loosen the right front 1/4 x 20 bolt. The side burner lock fits between the front panel and the frame. The “U” shape cut out slips up over the bolt. Tighten with a wrench. Figure 3 (b).
(a)
(b)
Figure 3
Step 5
Measure and drill holes
You will need: Completed frame assembly, base panel, tape measure, and pencil.
mCAUTION: Combustible materials should never be within 24 inches of the top, bottom, back or sides of the barbecue. Do not locate under overhead combustible construction.
Note - With the lid open the depth of the barbecue is 28 inches, front to back.
Set the completed frame assembly in position on your deck, concrete pad, or patio for anchoring. Measure the distance from the outside of the base plate to the outside of the other base plate. It should be 37 1/4” across. Figure 4.
Note: If the measurement is not 37 1/4” across adjust the legs as necessary so that the measurement is 37 1/4”.
Figure 4
Place the base panel in between the legs to insure fit. Figure 5. Once the fit is established, remove the base panel and mark the holes.
mCAUTION: A minimum of 2 bolts are required on each side.
You are now ready to anchor the base.
Figure 5
14