Weber 3500 LX owner manual Install Lid, Add tool holders, control panel and burner control knobs

Page 25

Step 20

Install Lid

You will need: lid, two hinge pins and two hair pin cotters.

Set the lid in place. Align the hinges at the rear of the barbecue. Insert hinge pins from the outside. Insert hair pin cotters into the small holes in the hinge pins. Figure 32.

Hair pin cotter

Hinge pin

Step 21

Add tool holders, control panel and burner control knobs

You will need: three tool holders, control panel, two Phillips screws/washers, a Phillips screwdriver, and three burner control knobs.

Hook the tool holders over the frame rail and snap down into place. Figure 33.

Set the control panel in place over both frame braces. (Hold the Crossover Ignition button up while setting the control panel in place.) Line up the holes in the control panel with the holes in the inserts in the frame brace. Insert screws and tighten with a Phillips screwdriver until snug. Do not overtighten. Figure 33 (a).

Push on the burner control knobs. Figure 33 (b).

Crossover

Insert in

frame brace

(a)

Figure 32

Ignition Button

Control panel

Phillips screws/

washers

Tool holders

(b)

Figure 33

25

Image 25

Contents Genesis 3500 LX LP GAS Units only MDANGER MWARNINGSWarranty Patents and Trademarks Contents General Instructions Gas supply testingStorage Operating areaGeneral Specifications for Piping Typical natural gas supply installation to a wood deck Recommended concrete pad requirements Check package contents AssemblyStep Page Check contents of hardware packs Assemble frame Continue frame assemblyMeasure and drill holes Install side burner locksMCAUTION a minimum of 2 bolts are required on each side Method 1 Concrete Method 3 Concrete Method 2 ConcreteMethod 4 Wood deck Add cooking box Tighten all frame boltsSpacer a bracket Frame cross piece Connect barbecue gas supply line to the natural gas supply Install igniterCheck all valves are off Install side burnerMWARNING Make sure gas supply is OFF Purge air from gas lines Install manifold bracketMWARNING Do not ignite burners while leak checking Check for gas leaksAdd base panel Install side panelsInstall the bottom tray Install Flavorizer Bars and Cooking GratesAdd tool holders, control panel and burner control knobs Install LidSecure side burner Install the condiment basketMCAUTION Make sure both locks have snapped into place Complete accessory installation Install the accessory rackTo Extinguish LightingManual Lighting Lighting only the side burner. Figure Lighting the side burnerCooking Periodic CleaningAfter a Period of Nonuse Drippings and greaseInspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceMCAUTION Do not enlarge the burner ports when cleaning General MaintenanceWeber Spider Stopper Guards Main Burner Flame PatternTo reinstall the burners, reverse steps c through g Crossover Ignition System Operations MCAUTION Do not line the bottom tray with aluminum foil Burner does not light, or flame is low in High positionSide Burner Maintenance Side Burner Troubleshooting16, 17 18 46-50 51-52,50 Parts List Final Word of Thanks