Weber 3500 LX owner manual Manual Lighting

Page 29

Manual Lighting

mDANGER

Failure to open lid while igniting the barbecue, or not waiting 5 minutes to allow the gas to clear if the barbecue does not light, may result in an explosive flame-up which can cause serious bodily injury or death.

1)Open the lid. Figure 2.

2)Make sure all burner control knobs are turned OFF. (Push each burner control knob down and turn clockwise.)

3)Turn gas supply valve on.

4)Strike a match and put the flame into the matchlight hole in the front of the cooking box.

Manual Lighting

1

7

27

4, 6

5

Figure 2

mWARNING: Do not lean over open barbecue. Keep your face and body at least one foot away from the matchlight hole when lighting the barbecue.

5)Push Front burner control knob down and turn to START/ HI.

6)Check that the burner is lit by looking through the matchlight hole on the front of the cooking box.

mWARNING: If the burner does not light, turn the Front burner control knob to OFF and wait 5 minutes to let the gas clear before you try again or try to light with a match.

7)After the FRONT burner is lit you can turn on the other burners.

Note - Always light the FRONT burner first. The other burners ignite from the FRONT burner.

To Extinguish

Turn gas supply OFF at the source, then push down and turn each burner control knob clockwise to OFF.

29

Image 29
Contents Genesis 3500 LX LP GAS Units only MDANGER MWARNINGSWarranty Patents and Trademarks Contents General Instructions Gas supply testingStorage Operating areaGeneral Specifications for Piping Typical natural gas supply installation to a wood deck Recommended concrete pad requirements Step AssemblyCheck package contents Page Check contents of hardware packs Assemble frame Continue frame assemblyMCAUTION a minimum of 2 bolts are required on each side Install side burner locksMeasure and drill holes Method 1 Concrete Method 4 Wood deck Method 2 ConcreteMethod 3 Concrete Add cooking box Tighten all frame boltsSpacer a bracket Frame cross piece Connect barbecue gas supply line to the natural gas supply Install igniterMWARNING Make sure gas supply is OFF Install side burnerCheck all valves are off Purge air from gas lines Install manifold bracketMWARNING Do not ignite burners while leak checking Check for gas leaksAdd base panel Install side panelsInstall the bottom tray Install Flavorizer Bars and Cooking GratesAdd tool holders, control panel and burner control knobs Install LidMCAUTION Make sure both locks have snapped into place Install the condiment basketSecure side burner Complete accessory installation Install the accessory rackTo Extinguish LightingManual Lighting Lighting only the side burner. Figure Lighting the side burnerCooking Periodic CleaningAfter a Period of Nonuse Drippings and greaseInspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceMCAUTION Do not enlarge the burner ports when cleaning General MaintenanceWeber Spider Stopper Guards Main Burner Flame PatternTo reinstall the burners, reverse steps c through g Crossover Ignition System Operations MCAUTION Do not line the bottom tray with aluminum foil Burner does not light, or flame is low in High positionSide Burner Maintenance Side Burner Troubleshooting16, 17 18 46-50 51-52,50 Parts List Final Word of Thanks