Weber 3500 LX owner manual Add base panel, Install side panels

Page 23

Step 16

Add base panel

You will need: Base panel.

Put the right side in and down, tilt and set the left side in place. Figure 25.

Step 17

Install side panels

You will need: two side panels, and eight plastic buttons.

From the inside of the frame assembly, set the left side panel in place between the side frame legs.

Notice that there are two sets of holes in each side panel. Align the holes in the side panel to match the holes in the left side frame legs. Push in the four plastic buttons.

Figure 26 (a).

Repeat with the right side panel.

top

Base panel	Left side
	panel

Figure 25

	Right side
bottom	panel
bottom

(a)

Figure 26

23

Image 23

Contents Genesis 3500 LX LP GAS Units only MDANGER MWARNINGSWarranty Patents and Trademarks Contents Operating area Gas supply testingGeneral Instructions StorageGeneral Specifications for Piping Typical natural gas supply installation to a wood deck Recommended concrete pad requirements Step AssemblyCheck package contents Page Check contents of hardware packs Assemble frame Continue frame assemblyMCAUTION a minimum of 2 bolts are required on each side Install side burner locksMeasure and drill holes Method 1 Concrete Method 4 Wood deck Method 2 ConcreteMethod 3 Concrete Add cooking box Tighten all frame boltsSpacer a bracket Frame cross piece Connect barbecue gas supply line to the natural gas supply Install igniterMWARNING Make sure gas supply is OFF Install side burnerCheck all valves are off Purge air from gas lines Install manifold bracketMWARNING Do not ignite burners while leak checking Check for gas leaksAdd base panel Install side panelsInstall the bottom tray Install Flavorizer Bars and Cooking GratesAdd tool holders, control panel and burner control knobs Install LidMCAUTION Make sure both locks have snapped into place Install the condiment basketSecure side burner Complete accessory installation Install the accessory rackTo Extinguish LightingManual Lighting Lighting only the side burner. Figure Lighting the side burnerDrippings and grease Periodic CleaningCooking After a Period of NonuseInspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceMain Burner Flame Pattern General MaintenanceMCAUTION Do not enlarge the burner ports when cleaning Weber Spider Stopper GuardsTo reinstall the burners, reverse steps c through g Crossover Ignition System Operations MCAUTION Do not line the bottom tray with aluminum foil Burner does not light, or flame is low in High positionSide Burner Maintenance Side Burner Troubleshooting16, 17 18 46-50 51-52,50 Parts List Final Word of Thanks