Weber 3500 LX owner manual Method 1 Concrete

Page 15

Step 6

Typical installation of the base for an existing concrete patio, new pad or wood deck

mCAUTION: Combustible materials should never be within 24 inches of the top, bottom, back or sides of the barbecue. Do not locate under overhead combustible construction.

Note - With the lid open the depth of the barbecue is 28 inches, front to back.

For anchoring, we recommend use of one of the following methods:

mWARNING: Whichever method used, the base must be bolted down (anchored) at a minimum of four anchoring points (two per side) prior to barbecue assembly. One anchor in each corner of the base plate. Figure 6.

1

4

2

3

Figure 6

Typical installation of the base for an existing concrete patio, new pad or wood deck (continued)

Method 1 - Concrete

A strike anchor, a minimum size of 3/8 inch x 3 1/2 inches long with a 3/8 inch flat washer and 3/8 inch nut. Figure 7.

Note - Use a 3/8 inch diameter concrete drill bit for drilling the hole for the strike anchor.

Strike anchor

3/8 inch nut

3/8 inch flat washer

Mount plate

Drilled hole

Figure 7

15

Image 15

Contents Genesis 3500 LX LP GAS Units only MDANGER MWARNINGSWarranty Patents and Trademarks Contents Operating area Gas supply testingGeneral Instructions StorageGeneral Specifications for Piping Typical natural gas supply installation to a wood deck Recommended concrete pad requirements Assembly Check package contentsStep Page Check contents of hardware packs Assemble frame Continue frame assemblyInstall side burner locks Measure and drill holesMCAUTION a minimum of 2 bolts are required on each side Method 1 Concrete Method 2 Concrete Method 3 ConcreteMethod 4 Wood deck Add cooking box Tighten all frame boltsSpacer a bracket Frame cross piece Connect barbecue gas supply line to the natural gas supply Install igniterInstall side burner Check all valves are offMWARNING Make sure gas supply is OFF Purge air from gas lines Install manifold bracketMWARNING Do not ignite burners while leak checking Check for gas leaksAdd base panel Install side panelsInstall the bottom tray Install Flavorizer Bars and Cooking GratesAdd tool holders, control panel and burner control knobs Install LidInstall the condiment basket Secure side burnerMCAUTION Make sure both locks have snapped into place Complete accessory installation Install the accessory rackTo Extinguish LightingManual Lighting Lighting only the side burner. Figure Lighting the side burnerDrippings and grease Periodic CleaningCooking After a Period of NonuseInspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceMain Burner Flame Pattern General MaintenanceMCAUTION Do not enlarge the burner ports when cleaning Weber Spider Stopper GuardsTo reinstall the burners, reverse steps c through g Crossover Ignition System Operations MCAUTION Do not line the bottom tray with aluminum foil Burner does not light, or flame is low in High positionSide Burner Maintenance Side Burner Troubleshooting16, 17 18 46-50 51-52,50 Parts List Final Word of Thanks