d)Unlatch the Spider Stopper Guards and remove. Figure 11.
Figure 11
e)Disconnect gas supply line and side burner.
f)Remove the manifold bracket and unscrew the two wing nuts that hold the manifold to the cooking box. Pull the manifold and valve assembly out of the burners and carefully set it down. Figure 12.
View from behind cooking box
Wing nuts
Figure 12
g)Slide the burner assembly out from under the guide screw and washer in the corners of the cooking box. Figure 13.
Guide screw
Figure 13
h)Lift and twist the burner assembly slightly, to separate the crossover tube from the burners. Figure 14. Remove the burners from the cooking box.
Crossover tube
Figure 14
i)To reinstall the burners, reverse steps c) through g).
mCAUTION: The burner openings must be positioned properly over the valve orifices. Figure 15 (a).
Check proper assembly before fastening manifold in place. Figure 15 (b).
Burner opening
(a)
Valve 
orifice
(b)
Figure 15
34