Weber 3500 LX owner manual Crossover Ignition System Operations

Page 35

j)Reinstall the Spider Stopper Guards. Slightly rotate the Spider Stopper Guards so that the seams are in line with the Venturi fins. There should be no gaps in the seams or in the fit around the burners and valves. Figure 16.

Check fit around valve

Venturi fin

Check fit around burner

Figure 16

mCAUTION: If the Spider Stopper Guards do not fit tightly, contact Weber-Stephen Customer Service.

k) Reconnect gas supply line. See “Check for gas leaks”.

Crossover Ignition System Operations

If the Crossover Ignition System fails to ignite the Front burner, light the Front burner with a match. If the Front burner lights with a match, then check the Crossover Ignition System.

■Check that both the white and black ignition wires are attached properly. Figure 17.

White wire

Black wire

Figure 17

■Check that the Crossover Ignition button pushes the igniter (button) down, and returns to the up position.

■Check to see if the igniter is loose in the frame. Tighten if necessary; see Step “Install igniter” for correct procedure.

If the Crossover Ignition System still fails to light, See Section "Manual Lighting", and contact Weber-Stephen Customer Service.

35

Image 35

Contents Genesis 3500 LX LP GAS Units only MDANGER MWARNINGSWarranty Patents and Trademarks Contents Operating area Gas supply testingGeneral Instructions StorageGeneral Specifications for Piping Typical natural gas supply installation to a wood deck Recommended concrete pad requirements Step AssemblyCheck package contents Page Check contents of hardware packs Assemble frame Continue frame assemblyMCAUTION a minimum of 2 bolts are required on each side Install side burner locksMeasure and drill holes Method 1 Concrete Method 4 Wood deck Method 2 ConcreteMethod 3 Concrete Add cooking box Tighten all frame boltsSpacer a bracket Frame cross piece Connect barbecue gas supply line to the natural gas supply Install igniterMWARNING Make sure gas supply is OFF Install side burnerCheck all valves are off Purge air from gas lines Install manifold bracketMWARNING Do not ignite burners while leak checking Check for gas leaksAdd base panel Install side panelsInstall the bottom tray Install Flavorizer Bars and Cooking GratesAdd tool holders, control panel and burner control knobs Install LidMCAUTION Make sure both locks have snapped into place Install the condiment basketSecure side burner Complete accessory installation Install the accessory rackTo Extinguish LightingManual Lighting Lighting only the side burner. Figure Lighting the side burnerDrippings and grease Periodic CleaningCooking After a Period of NonuseInspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceMain Burner Flame Pattern General MaintenanceMCAUTION Do not enlarge the burner ports when cleaning Weber Spider Stopper GuardsTo reinstall the burners, reverse steps c through g Crossover Ignition System Operations MCAUTION Do not line the bottom tray with aluminum foil Burner does not light, or flame is low in High positionSide Burner Maintenance Side Burner Troubleshooting16, 17 18 46-50 51-52,50 Parts List Final Word of Thanks