Weber 3500 LX owner manual Spacer a bracket Frame cross piece

Slide the cooking box to the left within the frame. Put the washer on the bolt. Take the spacer bracket and hold it up to the frame making sure both tabs fit underneath the frame cross piece. Figure 14 (a). Insert the bolt through the center hole in the spacer bracket, frame and cooking box with the head of the bolt outside the spacer bracket. Figure 14 (b). Add keps nut. Tighten by holding the bolt with pliers while you tighten the nut with the 7/16 inch wrench.

Your Weber Gas Barbecue burner assembly has been factory assembled, pressure and flame tested. As a safety precaution we recommend you check the burner alignment:

a)	Are the ends of the burners under the washers at the
	left rear and left front of the cooking box? The screws
	are only guides. Do not tighten. Figure 15 (a).
b)	Are the wing nuts under the burner assembly hand
	tight? Do not tighten with pliers. Figure 15 (b).

Spacer (a) bracket

Frame cross piece

If you answered YES to a and b, the burners are correctly aligned. If you answered NO, the burners are misaligned. Contact Weber-Stephen Customer Service. Do not use barbecue.

Guide screw

(b) Tab

Keps nut

Bolt Nylon washer

Figure 14

(a)

View from behind cooking box

(b)

Figure 15

Wing nuts

18