Weber 5000 owner manual Assemble wheels, Assemble frame

Page 11

Step 2

Assemble wheels

You will need: axle, two wheel hubcaps, two wheels, wheel frame, hammer and a block of wood.

Place one end of the axle on the block of wood (or other protected surface). Tap on one hubcap.

Put one wheel on the axle, WEBER side toward the hubcap. Slide the axle through the frame. Add the other wheel, WEBER side out. Tap on the hubcap. Figure 1.

 

R

W

E

EB

 

E

W

 

 

B

 

 

RE

Step 3

Assemble frame

You will need: left frame, right frame, two nylon washers, two 1/4-20 x 1/2 inch bolts and a 7/16 inch wrench.

Note - Work on carpeted area (on grass, or on one of the boxes) to protect the finish during frame assembly.

Put the frame pieces so the leg tabs are up. Put the right frame to your right and left frame to your left. Figure 2.

Slip the two frame halves together with the tabs inside, until the tabs of the right frame are inside the left frame and the holes align. Figure 2 (a).

Slip washers over bolts; insert and tighten bolts. (If you try to insert a bolt and there are no holes, you have the left frame turned the wrong way. Turn the left frame around.) Figure 2 (b).

Figure 1

(a)

Leg tabs

Frame tabs

Right frame

Left frame

(b)

Figure 2

11

Image 11
Contents Genesis 5000 Series LP GAS Units only Warranty Patents and Trademarks Contents Storage For Installation in CanadaGas supply testing General InstructionsStep AssemblyCheck package contents Page Page Check contents of hardware packs Assemble frame Assemble wheelsComplete frame assembly Continue frame assemblyInsert casters Check the frame assemblyInstall left end panel Install side burner locks Install the three back panelsAdd cooking box Gas line piping Install gas supplyGeneral Specifications for Piping Typical natural gas supply installation. FigureConnect flexible hose to manifold Install side burnerCheck that all burner valves are off Install right end panel Install manifold bracketInstall brace panel Install igniter Install bottom accessory traysInstall left hand swing table Install right hand swing table Hinge rod View from rear of barbecue Check for gas leaks Insert Flavorizer Bars Steam-N-Chips Smoker BARBECUE. Contact Weber-Stephen Customer ServiceInstall the bottom tray Install cooking gratesInstall the lid Secure the side burner Install glass doorsComplete accessory installation To Extinguish LightingOr death Side burner will only operate when the Front burner is litManual Lighting Lighting the side burnerDrippings and grease Periodic CleaningCooking Storage and/or NonuseTo use the Steam-N-Chips Smoker Using the Steam-N-Chips SmokerInspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceMain Burner Flame Pattern General MaintenanceMain Burner Cleaning Procedure Weber Spider Stopper GuardsView from behind cooking box Thumb screws Crossover Ignition System Operations FlameCheck Safety System Experiencing flare-ups Burner does not light, or flame is low in High positionFlame is low in High position Side Burner TroubleshootingSide Burner Maintenance Problem Check Cure Side burner does not lightPage Page 19-20 22-24 68-71 Parts List Final Word Thanks
Related manuals
Manual 48 pages 899 b