Manual Lighting
DANGER
Failure to open lid while igniting the barbecue, or not waiting 5 minutes to allow the gas to clear if the barbecue does not light, may result in an explosive flame- up which can cause serious bodily injury or death.
1)Open the lid. Figure 2.
2)Make sure all burner control knobs are turned OFF. (Push each knob down and turn clockwise.)
3)Turn gas supply valve on.
4)Push Front burner control knob down and turn to START/HI.
WARNING: Do not lean over open barbecue. Keep your face and body at least one foot away from the matchlight hole when lighting the barbecue.
5)Push down and hold the FlameCheck button down.
8)After the FRONT burner is lit you can turn on the other burners.
Note - The FRONT burner must be on at all times when operating the other burners. The FlameCheck Safety System monitors the Front burner. For your safety, the FlameCheck valve will shut off the gas to the burners if the front burner should inadvertently go out during cooking.
To Extinguish
Turn gas supply OFF at the source, then push down and turn each burner control knob clockwise to OFF.
Lighting the side burner
The side burner has a separate ignition system from the main cooking box.
DANGER
Failure to open lid while igniting the side burner, or not waiting 5 minutes to allow gas to clear if the side burner does not light, may result in an explosive flame- up which can cause serious bodily injury
1
6
7 4 5
Manual Lighting
2
8
3
or death.
The side burner will only operate when the Front burner is lit.
1)Open the side burner lid. Figure 3.
2)Push down and turn the side burner control to HI.
3)Push the side burner igniter button several times so it clicks each time.
CAUTION: Side burner flame may be difficult to see on a bright sunny day.
WARNING: If the side burner does not light:
Figure 2
6)Strike a match and put the flame into the matchlight hole in the front of the cooking box.
Note - Gas is supplied to the burner only when the FlameCheck button is depressed.
7)Check that the burner is lit by looking through the matchlight hole on the front of the cooking box.
If the burner is lit, continue to hold the FlameCheck button down for about 8 seconds. When the button is released the burner will stay lit.
WARNING: If the burner does not light, turn the Front burner control knob to OFF and wait 5 minutes to let the gas clear before you try again or try to light with a match.
a)Turn OFF the side burner control valve.
b)Wait 5 minutes to let the gas clear before you try again or try to light with a match.
1
2
3
Figure 3
30