Weber 5000 owner manual Lighting, To Extinguish

Page 29

OPERATING INSTRUCTIONS

Lighting

Summary lighting instructions are on the control panel.

DANGER

Failure to open lid while igniting the barbecue, or not waiting 5 minutes to allow the gas to clear if the barbecue does not light, may result in an explosive flame- up which can cause serious bodily injury or death.

Crossover Ignition System

Note - The Crossover Ignition System ignites the Front burner with a spark from the igniter electrode inside the Gas Catcher Ignition Chamber. You generate the energy for the spark by pushing the Crossover Ignition Button until it clicks.

WARNING: Check hose before each use of barbecue for nicks, cracking, abrasions or cuts. If the hose is found to be damaged in any way, do not use the barbecue. Replace using only Weber authorized replacement hose. Order from Weber- Stephen Products Co., Customer Service Center or authorized dealer.

3)Turn gas supply valve on.

4)Push Front burner control knob down and turn to START/HI.

WARNING: Do not lean over open barbecue. Keep your face and body at least one foot away from the matchlight hole when lighting the barbecue.

5) Push down the FlameCheck button and hold down.

Note - Gas is supplied to the burner only when the FlameCheck button is depressed.

6)Push the Crossover Ignition button several times, so that it clicks each time.

7)Check that the burner is lit by looking through the matchlight hole on the front of the cooking box.

If the burner is lit, continue to hold the FlameCheck button down for about 8 seconds. When the button is released the burner will stay lit.

WARNING: If the burner does not light, turn the Front burner control knob to OFF and wait 5 minutes to let the gas clear before you try again or try to light with a match.

8)After the FRONT burner is lit you can turn on the other burners.

1

6

7 4 5

Crossover Ignition System

2

8

3

Note - The FRONT burner must be on at all times when operating the other burners. The FlameCheck Safety System monitors the Front burner. For your safety, the FlameCheck valve will shut off the gas to the burners if the front burner should inadvertently go out during cooking.

To Extinguish

Turn gas supply OFF at the source, then push down and turn each burner control knob clockwise to OFF.

Figure 1

1)Open the lid. Figure 1.

2)Make sure all burner control knobs are turned OFF. (Push each knob down and turn clockwise.)

29

Image 29
Contents Genesis 5000 Series LP GAS Units only Warranty Patents and Trademarks Contents Gas supply testing For Installation in CanadaGeneral Instructions StorageStep AssemblyCheck package contents Page Page Check contents of hardware packs Assemble frame Assemble wheelsComplete frame assembly Continue frame assemblyInsert casters Check the frame assemblyInstall left end panel Install side burner locks Install the three back panelsAdd cooking box General Specifications for Piping Install gas supplyTypical natural gas supply installation. Figure Gas line pipingConnect flexible hose to manifold Install side burnerCheck that all burner valves are off Install right end panel Install manifold bracketInstall brace panel Install igniter Install bottom accessory traysInstall left hand swing table Install right hand swing table Hinge rod View from rear of barbecue Check for gas leaks Insert Flavorizer Bars Steam-N-Chips Smoker BARBECUE. Contact Weber-Stephen Customer ServiceInstall the bottom tray Install cooking gratesInstall the lid Secure the side burner Install glass doorsComplete accessory installation To Extinguish LightingManual Lighting Side burner will only operate when the Front burner is litLighting the side burner Or deathCooking Periodic CleaningStorage and/or Nonuse Drippings and greaseTo use the Steam-N-Chips Smoker Using the Steam-N-Chips SmokerInspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceMain Burner Cleaning Procedure General MaintenanceWeber Spider Stopper Guards Main Burner Flame PatternView from behind cooking box Thumb screws Crossover Ignition System Operations FlameCheck Safety System Experiencing flare-ups Burner does not light, or flame is low in High positionSide Burner Maintenance Side Burner TroubleshootingProblem Check Cure Side burner does not light Flame is low in High positionPage Page 19-20 22-24 68-71 Parts List Final Word Thanks
Related manuals
Manual 48 pages 899 b