Weber 5000 owner manual Continue frame assembly, Complete frame assembly

Page 12

Step 4

Continue frame assembly

You will need: frame assembly, wheel frame assembly, front panel, caster frame, four 1/4-20 x 1/2 inch bolts, four nylon washers and a 7/16 inch wrench.

Place the caster frame onto the tabs of the left frame with the dimple to the inside. Figure 3. Place the wheel frame onto the tabs of the right frame with the dimple to the inside. Figure 3.

The leg tabs must be on the inside of the frames.

Add front panel with the hole down and to your right. Add the washers to the bolts, insert in the holes as shown. Only start the bolts at the wheel frame, figure 3 (a) & (b), and tighten the bolts at the caster frame.

Dimples to the inside

Only start this bolt

Figure 3

Step 5

Complete frame assembly

You will need: partial frame assembly, one frame connector with bushings, one frame connector without bushings, four 1/4-20 x 2 inch bolts, four nylon washers and a 7/16 inch wrench.

Hold the frame connector, bushing side down, between the caster and wheel frame, above the front panel. Add nylon washers to the bolts, put the bolts through the frame and screw into the frame connector. Tighten.

The second frame connector has no bushings, place it between the caster frame and the wheel frame. Add a nylon washer to the bolt, put the bolts through the frame and screw into the frame connector. Tighten. Figure 4.

Bushings down

Figure 4

12

Image 12
Contents Genesis 5000 Series LP GAS Units only Warranty Patents and Trademarks Contents For Installation in Canada Gas supply testingGeneral Instructions StorageAssembly Check package contentsStep Page Page Check contents of hardware packs Assemble wheels Assemble frameContinue frame assembly Complete frame assemblyCheck the frame assembly Install left end panelInsert casters Install the three back panels Install side burner locksAdd cooking box Install gas supply General Specifications for PipingTypical natural gas supply installation. Figure Gas line pipingInstall side burner Check that all burner valves are offConnect flexible hose to manifold Install manifold bracket Install brace panelInstall right end panel Install bottom accessory trays Install igniterInstall left hand swing table Install right hand swing table Hinge rod View from rear of barbecue Check for gas leaks BARBECUE. Contact Weber-Stephen Customer Service Insert Flavorizer Bars Steam-N-Chips SmokerInstall cooking grates Install the bottom trayInstall the lid Install glass doors Secure the side burnerComplete accessory installation Lighting To ExtinguishSide burner will only operate when the Front burner is lit Manual LightingLighting the side burner Or deathPeriodic Cleaning CookingStorage and/or Nonuse Drippings and greaseUsing the Steam-N-Chips Smoker To use the Steam-N-Chips SmokerAnnual Maintenance Inspection and Cleaning of the Weber Spider Stopper GuardsGeneral Maintenance Main Burner Cleaning ProcedureWeber Spider Stopper Guards Main Burner Flame PatternView from behind cooking box Thumb screws Crossover Ignition System Operations FlameCheck Safety System Burner does not light, or flame is low in High position Experiencing flare-upsSide Burner Troubleshooting Side Burner MaintenanceProblem Check Cure Side burner does not light Flame is low in High positionPage Page 19-20 22-24 68-71 Parts List Final Word Thanks
Related manuals
Manual 48 pages 899 b