Weber 4000 owner manual Install right hand swing table

Position slide bar assembly on the outside of the caster frame. Put a nylon washer on each 1 3/4 inch screw, insert screws through frame and slide bar assembly and add nylon washers and hex nuts. Tighten nuts using a screwdriver and pliers. Figure 19.

Notch to the front

Slide bar

View from front of barbecue

Figure 19

To lower table: Pull support rod up to disengage slide lock, and lower table. To raise table, lift table up and engage slide in locked position. Figure 20.

Support rod

View from rear of barbecue

Slide

Unlocked position Locked position

Figure 20

Step 16

Install right hand swing table

You will need: swing table end bracket, two 10-24 hex nuts, two 10-24 x 1 3/4 inch machine screws, right hand slide bar assembly, swing table, four nylon washers, screwdriver and pliers.

Allow the slide bar to hang down. Push the support rod into the lower support bracket. Figure 21 (a). Swing the rod up so you can slide the rod all the way inside the locking tab. Figure 21 (b). The rod should swing freely inside the locking tab. Figure 21 (c).

View from rear

(b) (c)

Support rod

(a)

Slide bar assembly

Figure 21

18