Weber 4000 owner manual Install the lid

Page 25

Step 24

Install the lid

You will need: lid, two hinge pins and two hair pin cotters.

Set the lid in place. Align the hinges at the rear of the barbecue. Insert hinge pins from the outside. Insert hair pin cotters into the small holes in the hinge pins. Figure 38.

Hair pin cotter

Hinge pin

Figure 38

Step 25

Install tool holders, control panel, burner control knobs and FlameCheck button

You will need: three tool holders, control panel, three burner control knobs and FlameCheck button.

Hook the tool holders over the frame rail. Figure 39.

Set the control panel in place over both frame braces. (Hold the Crossover Ignition button up while setting the control panel in place.) Place your thumbs over the control panel push-in buttons and push them into the frame brace until they snap into place. Figure 39 (a).

Push on the burner control knobs and FlameCheck button. Figure 39 (b).

Hole in frame brace

(a)

Control panel push-in buttons

(b)

Tool holders

Figure 39

25

Image 25
Contents Genesis 4000 Series LP GAS Units only Warranty Patents and Trademarks Contents General Instructions For Installation in CanadaStorage Operating areaCheck package contents AssemblyStep Page Page Check contents of hardware packs Assemble frame Assemble wheelsComplete frame assembly Continue frame assemblyInsert casters Add cooking box Install side burner locksAdd fuel scale Install tank panel assemblyCheck that all burner valves are off Install igniterInstall manifold bracket Install side burnerInstall left hand swing table Install right hand swing table Hinge rod View from rear of barbecue Fill LP tank Set LP fuel scaleWing nut Connect LP tankCheck for gas leaks Insert Flavorizer Bars Steam-N-Chips Smoker BARBECUE. Contact Weber-Stephen Customer ServiceInstall the bottom tray Install cooking gratesInstall the lid Secure side burner Complete accessory installationTo Extinguish LightingValve and burner control knobs and start over Try to light with a matchManual Lighting Lighting the side burner Side burner will only operate when the Front burner is litCooking Periodic CleaningStorage and/or Nonuse Storage and/or NonuseTo use the Steam-N-Chips Smoker Using the Steam-N-Chips SmokerRemoval of the LP tank Refilling the LP tankMale fitting Regulator Collar Quick disconnect engaged Liquid Propane LP Tanks Safe handling tips for LP GasInspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceWeber Spider Stopper Guards General MaintenanceMain Burner Flame Pattern Replacing Main BurnersView from behind cooking box Wing nuts Crossover Ignition System Operations FlameCheck Safety System Burner does not light, or flame is low in High position When burner is on HIGH. Flames do not runBurner flame pattern is erratic. Flame is low Resembles paint peelingSide Burner Maintenance Side Burner TroubleshootingProblem Check Cure Side burner does not light Flame is low in High position18-19 21-22 Parts List Final Word Thanks