Weber 4000 owner manual FlameCheck Safety System

Page 39

FlameCheck Safety System

The correct positioning of the thermocouple probe is shown in Figure 23. The tip of the probe is positioned in the flame. The probe senses the heat from the Front burner, and activates the FlameCheck valve. The valve allows the gas to flow into the Front burner. If the Front burner should go out for any reason, the thermocouple probe will cool off, thereby closing the FlameCheck valve, which stops the gas flow to the burners.

If the FlameCheck Safety System should fail to operate, contact Weber-Stephen Customer Service.

Center line

Thermocouple nuts

1/8 inch

Ignition holes

Wall of cooking box

Figure 23

39

Image 39

Contents Genesis 4000 Series LP GAS Units only Warranty Patents and Trademarks Contents Operating area For Installation in CanadaGeneral Instructions StorageAssembly Check package contentsStep Page Page Check contents of hardware packs Assemble frame Assemble wheelsContinue frame assembly Complete frame assemblyInsert casters Add cooking box Install side burner locksAdd fuel scale Install tank panel assemblyCheck that all burner valves are off Install igniterInstall manifold bracket Install side burnerInstall left hand swing table Install right hand swing table Hinge rod View from rear of barbecue Fill LP tank Set LP fuel scaleWing nut Connect LP tankCheck for gas leaks Insert Flavorizer Bars Steam-N-Chips Smoker BARBECUE. Contact Weber-Stephen Customer ServiceInstall the bottom tray Install cooking gratesInstall the lid Secure side burner Complete accessory installationTry to light with a match LightingTo Extinguish Valve and burner control knobs and start overManual Lighting Lighting the side burner Side burner will only operate when the Front burner is litStorage and/or Nonuse Periodic CleaningCooking Storage and/or NonuseTo use the Steam-N-Chips Smoker Using the Steam-N-Chips SmokerRemoval of the LP tank Refilling the LP tankMale fitting Regulator Collar Quick disconnect engaged Liquid Propane LP Tanks Safe handling tips for LP GasInspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceReplacing Main Burners General MaintenanceWeber Spider Stopper Guards Main Burner Flame PatternView from behind cooking box Wing nuts Crossover Ignition System Operations FlameCheck Safety System Resembles paint peeling When burner is on HIGH. Flames do not runBurner does not light, or flame is low in High position Burner flame pattern is erratic. Flame is lowFlame is low in High position Side Burner TroubleshootingSide Burner Maintenance Problem Check Cure Side burner does not light18-19 21-22 Parts List Final Word Thanks