Console Setup Mode

The Console Setup Mode lets you set the units of measurement to either English or Metric, change the machine type, or see maintenance statistics (Error Log and Run Hours – for service technician use only).

1.Hold down the Increase button and Decrease button together for 3 seconds while in the Power-Up Mode to go into the Console Setup Mode.

Note: Push STOP to go back to the previous screen or the Power-Up Mode screen.

2.The Console display shows the Units prompt. Push START/ENTER to start Units option. Push the Increase/Decrease buttons to change between “Miles-Lb” (Imperial English units) and

“Km-Kg” (metric units).

Note: If the units change when there is data in User Statistics, the statistics convert to the new units.

3.Push START/ENTER to set.

4.The Console display shows the Machine Type prompt. Push START/ENTER to start Machine

Type option. Push the Increase/Decrease buttons to change between ELLIPTICAL and BIKE.

5.Push START/ENTER to set.

6.The Console display shows the Brightness prompt. Push START/ENTER to start the brightness option. Push the Increase/Decrease buttons to change the brightness levels from 1 (brightest) to 5 (darkest).

7.Push START/ENTER to set.

8.The Console display shows the Error Log prompt. Push START/ENTER to start Error Log option. The Error Log stores the last 10 errors (error type and system time of error), listed newest to oldest. Push the Increase/Decrease buttons to move through the Error Log. If there are no errors, the Console display shows “Index=0”.

9.Push STOP to exit.

10.The Console shows the TOTAL HOURS prompt. Push START/ENTER to see total hours for the machine.

11.Push STOP to exit.

12.The Console display shows the Units prompt again. Push STOP to go back to the Power-Up Mode screen.