Invacare Pronto M61 manual Installing/Removing Flip Back Armrests

SECTION 6—ARMS

Installing/Removing Flip Back Armrests

WARNING

Make sure the flip back armrest release and height adjustment levers are in the locked position before using the wheelchair.

NOTE: For this procedure, refer to FIGURE 6.5 on page 38.

NOTE: Flip back armrest release lever must be in unlocked position when placing armrest into the arm sockets.

Installing

1.Slide the flip back armrest into the arm sockets on the wheelchair frame.

2.Install the quick release pin through the rear arm socket and flip back armrest.

3.Lock flip back armrest by pressing flip back armrest release lever into the locked (vertical) position.

4.Lift up on flip back armrest to make sure the armrest is locked in place.

5.Repeat STEPS 1‐4 for opposite flip back armrest.

Removing

1.Unlock flip back armrest by pulling flip back armrest release lever into the unlocked (horizontal) position.

2.Remove the quick release pin that secures the flip back armrest to the wheelchair frame.

3.Pull up on the flip back armrest and remove the armrest from the arm sockets.

4.Repeat STEPS 1‐3 for the opposite flip back armrest, if necessary.

Flip Back Armrest	Flip Back Armrest
	Release Lever

Rear Arm Socket

Locked

(Vertical)

Unlocked

(Horizontal)

Seat Frame

Quick Release Pin

Front Arm Socket

FIGURE 6.5 Installing/Removing Flip Back Armrests

Pronto® M51™and M61™with SureStep® 38 Part No 1125085