Invacare Pronto M61 manual Removing/Installing the Seat Assembly

Page 42

SECTION 7—SEAT

Removing/Installing the Seat Assembly

NOTE: For this procedure, refer to FIGURE 7.4.

Removing

1.Disconnect the joystick. Refer to Disconnecting/Connecting the Joystick on page 74.

2.Fold down the seat back.

3.Pull the seat lever up and lift the seat assembly up and away from the seat post.

Installing

1.Align the seat pivot with the seat post

2.Pull the seat lever up and lower the seat assembly on the seat post. NOTE: If necessary, slightly twist seat assembly back and forth to lock it in place.

3.Release the seat lever.

4.Pull the seat assembly up to ensure that it is locked in place.

5.Connect the joystick. Refer to Disconnecting/Connecting the Joystick on page 74.

Seat

Assembly

Seat Post

Seat Lever

NOTE: Office style van seat is shown. Standard van seat installs the same way.

NOTE: ASBA Seat installs the same way.

FIGURE 7.4 Removing/Installing the Seat Assembly

Pronto® M51™and M61™with SureStep®

42

Part No 1125085

Image 42
Contents Pronto M51and M61with SureStep Reference Documents Reference DocumentsDocument Table of Contents Table of Contents Register Your ProductSpecial Notes Special NotesMeaning Special Notes Label Location Label LocationTypical Product Parameters Typical Product ParametersAsba ShippingGeneral Guidelines Controller Settings/Repair or ServiceAccessories Operation InformationImmediately Batteries M61 Wheelchairs OnlyCharging Batteries Grounding Instructions Weight TrainingWeight Limitation Rain TestEMI Information EMI InformationEMI Information SAFETY/HANDLING of Wheelchairs SAFETY/HANDLING of WheelchairsStability and Balance Coping With Everyday Obstacles Coping With Everyday ObstaclesPinch Points Pinch PointsLifting/Stairways Transferring To and From Other Seats Lifting/StairwaysReaching, Leaning and Bending Forward Transferring To and From Other SeatsReaching and Bending Backward Reaching and Bending BackwardSafety INSPECTION/TROUBLESHOOTING Safety INSPECTION/ TroubleshootingSafety Inspection Checklists All WheelchairsInspect/Adjust Weekly Troubleshooting Guide Symptom Probable Cause SolutionsAdditional Requirements for M61 Wheelchairs About Joystick Diagnostics Display Description DefinitionService Indicator Light Diagnostics Possible SolutionChecking Battery Charge Level Additional Troubleshooting Information for M61 WheelchairsDON’T Wheelchair Operation Turning the Power On/OffUsing the Joystick to Drive the Wheelchair Operating the WheelchairAdjusting the Speed Movement ActionUsing the Horn Elevating the SeatElevating the Seat SPJ+ and SPJ+ w/ACC Joystick Switches and Indicators LEDSpeedometer Mode ButtonOn/Off Button Speed Control ButtonsCharger/Programming Input Service IndicatorJoystick Information Gauge DisplayAdjusting Width Removing/Installing the ArmsAdjusting the Arms ArmsAdjusting Angle Adjusting HeightInstalling/Removing Flip Back Armrests InstallingRemoving Positioning/Adjusting Flip Back Armrests Positioning Flip Back Armrests for User TransferPositioning Flip Back Armrests for Use Semi-Recline Back Angle Adjusting the Back AngleSeat Fold Down Back AngleAdjusting the Headrest Semi-Recline Only Adjusting the Back Angle Fold Down Back AngleRemoving/Installing the Seat Assembly Removing/Installing the Seat AssemblyReplacing the Seat Positioning Strap Van SeatAsba Seat Replacing the Seat Positioning Strap Asba SeatFootboard Assembly Removing/Installing the Footboard AssemblyFootboard Assembly Adjusting the Footboard Assembly AngleAdjusting the Footboard Assembly Angle DepthInstalling/Removing Front Riggings Front RiggingsFront Riggings Adjusting Footrest Height Model PHWH93Replacing Heel Loops Model PH904A and PHAL4AAdjusting/Replacing Telescoping Front Rigging Supports Raising/Lowering Elevating Front RiggingsOffice Style Seat Front Rigging Inch OUT Inches OUTPosition Standard Seat Inner Mounting Holes Mounting Screws Spacer Replacing the Flat Free Tires on the Wheel Rim Removing/Installing the Top ShroudTOP Shroud and Wheels TOP Shroud and WheelsEngaging/Disengaging Motor Release Lever TOP Shroud and WheelsReplacing Front/Rear Caster Assemblies Engaging/Disengaging Motor Release LeverAdjusting Forks Adjusting ForksBatteries BatteriesUsing the Proper Batteries Removing/Installing Batteries from/into Battery TrayBatteries Tool QTY Connecting/Disconnecting Battery Cables Connecting Battery CablesBatteries Caps not shown on front Disconnecting Battery Cables Charging BatteriesBattery Charger Operation On-Board Battery Charger ON/OFF Indicator Port Removing/Installing the Joystick ElectronicsElectronics Removing/Installing the Joystick Repositioning the JoystickRepositioning the Joystick Disconnecting/Connecting the Joystick DisconnectingConnecting Disconnecting/Connecting the Joystick Accessories Installing/Removing the Crutch/Cane HolderAccessories Installing/Removing the Oxygen Holder CylinderInstalling/Removing/Using the Walker Holder Installing/Removing the Walker HolderUsing the Walker Holder Global Limited Warranty Excluding Canada Global Limited Warranty Excluding CanadaCanada Limited Warranty USA