Invacare Pronto M61 Seat, Adjusting the Back Angle, Semi-Recline Back Angle, Fold Down Back Angle

SECTION 7—SEAT

SECTION 7—SEAT

WARNING

After any adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result.

Before performing any maintenance, adjustment or service verify that On/Off switch on the joystick is in the Off position.

Adjusting the Back Angle

Semi-Recline Back Angle

NOTE: For this procedure, refer to FIGURE 7.1.

1.Lift up on the release handle and adjust seat to desired angle.

2.Let go of the release handle to lock the back in position.

Release Handle	Office Style
	Van Seat

NOTE: Office style van seat is shown. Standard van seat operates the same way.

FIGURE 7.1 Adjusting the Back Angle - Semi-Recline Back Angle

Fold Down Back Angle

NOTE: For this procedure, refer to FIGURE 7.2 on page 41.

1.Remove the two shoulder bolts and locknuts from the seat hinges on either side of the seat.

2.Select one of the four back angle positions as shown in Detail “A” of FIGURE 7.2 on page 41.

3.Reinstall and tighten the two shoulder bolts and locknuts through the desired back angle setting on each seat hinge.

NOTE: Both seat hinges should be set to the same back angle setting.

Pronto® M51™and M61™with SureStep® 40 Part No 1125085