Invacare Pronto M61 manual On-Board Battery Charger

Page 68

SECTION 11—BATTERIES

On-Board Battery Charger

DANGER

When using an extension cord, use only a three wire extension cord having at least 16 AWG (American Wire Gauge) wire and the same or higher electrical rating as the device being connected. Use of improper extension cord could result in risk of fire and electric shock. Three prong to two prong adapters should not be used. Use of three prong adapters can result in improper grounding and present a shock hazard to the user.

WARNING

Ensure the pins of the extension cord plug are the same number, size, and shape as those on the charger.

DO NOT, under any circumstances, cut or remove the round grounding plug from the charger AC cable plug or the extension cord plug.

NOTE: For this procedure, refer to FIGURE 11.4 on page 69.

NOTE: The On/Off LED indicator light and the charger LED indicator light are located on the top of the charger on the rear of the wheelchair. Open rear shroud to view indicator lights.

NOTE: If the batteries are completely discharged, the charger will not charge them. Replace the batteries. Refer to Removing/Installing Batteries from/into Battery Tray on page 61.

1.Plug the female connector of the AC power cord (supplied) to the AC receptacle on the charger and plug in the male connector on the AC power cord into the wall outlet.

2.The On/Off LED indicator is blinking RED, this is abnormal. Unplug AC power cord from the on‐board battery charger and wall outlet. Charger may need to be replaced. Contact an Invacare dealer or qualified technician.

3.When the On/Off LED indicator light is Off, charger is Off.

4.When the Charge LED indicator light is YELLOW, the batteries are charging.

5.When the Charge LED indicator light is solid GREEN, the batteries are fully charged (as their condition will allow).

6.When charging is complete, unplug the male connector of the AC power cord from the wall outlet and then unplug the female connector of the AC power cord from the AC receptacle on the charger.

WARNING

DO NOT operate wheelchair with AC power cord attached to the wheelchair.

Pronto® M51™and M61™with SureStep®

68

Part No 1125085

Image 68
Contents Pronto M51and M61with SureStep Document Reference DocumentsReference Documents Table of Contents Table of Contents Register Your ProductMeaning Special NotesSpecial Notes Special Notes Label Location Label LocationTypical Product Parameters Typical Product ParametersAsba ShippingController Settings/Repair or Service AccessoriesGeneral Guidelines Operation InformationImmediately Charging Batteries BatteriesM61 Wheelchairs Only Weight Training Weight LimitationGrounding Instructions Rain TestEMI Information EMI InformationEMI Information Stability and Balance SAFETY/HANDLING of WheelchairsSAFETY/HANDLING of Wheelchairs Coping With Everyday Obstacles Coping With Everyday ObstaclesPinch Points Pinch PointsLifting/Stairways Transferring To and From Other Seats Lifting/StairwaysReaching, Leaning and Bending Forward Transferring To and From Other SeatsReaching and Bending Backward Reaching and Bending BackwardSafety INSPECTION/ Troubleshooting Safety Inspection ChecklistsSafety INSPECTION/TROUBLESHOOTING All WheelchairsInspect/Adjust Weekly Additional Requirements for M61 Wheelchairs Troubleshooting GuideSymptom Probable Cause Solutions About Joystick Diagnostics Display Description DefinitionService Indicator Light Diagnostics Possible SolutionDON’T Checking Battery Charge LevelAdditional Troubleshooting Information for M61 Wheelchairs Turning the Power On/Off Using the Joystick to Drive the WheelchairWheelchair Operation Operating the WheelchairAdjusting the Speed Movement ActionUsing the Horn Elevating the SeatElevating the Seat SPJ+ and SPJ+ w/ACC Joystick Switches and Indicators LEDMode Button On/Off ButtonSpeedometer Speed Control ButtonsService Indicator JoystickCharger/Programming Input Information Gauge DisplayRemoving/Installing the Arms Adjusting the ArmsAdjusting Width ArmsAdjusting Angle Adjusting HeightRemoving Installing/Removing Flip Back ArmrestsInstalling Positioning Flip Back Armrests for Use Positioning/Adjusting Flip Back ArmrestsPositioning Flip Back Armrests for User Transfer Adjusting the Back Angle SeatSemi-Recline Back Angle Fold Down Back AngleAdjusting the Headrest Semi-Recline Only Adjusting the Back Angle Fold Down Back AngleRemoving/Installing the Seat Assembly Removing/Installing the Seat AssemblyReplacing the Seat Positioning Strap Van SeatAsba Seat Replacing the Seat Positioning Strap Asba SeatFootboard Assembly Footboard AssemblyRemoving/Installing the Footboard Assembly Adjusting the Footboard Assembly AngleAdjusting the Footboard Assembly Angle DepthFront Riggings Installing/Removing Front RiggingsFront Riggings Adjusting Footrest Height Model PHWH93Replacing Heel Loops Model PH904A and PHAL4AOffice Style Seat Adjusting/Replacing Telescoping Front Rigging SupportsRaising/Lowering Elevating Front Riggings Position Front RiggingInch OUT Inches OUT Standard Seat Inner Mounting Holes Mounting Screws Spacer Removing/Installing the Top Shroud TOP Shroud and WheelsReplacing the Flat Free Tires on the Wheel Rim TOP Shroud and WheelsEngaging/Disengaging Motor Release Lever TOP Shroud and WheelsReplacing Front/Rear Caster Assemblies Engaging/Disengaging Motor Release LeverAdjusting Forks Adjusting ForksBatteries BatteriesUsing the Proper Batteries Removing/Installing Batteries from/into Battery TrayBatteries Tool QTY Connecting/Disconnecting Battery Cables Connecting Battery CablesBatteries Caps not shown on front Disconnecting Battery Cables Charging BatteriesBattery Charger Operation On-Board Battery Charger ON/OFF Indicator Port Electronics Removing/Installing the JoystickElectronics Removing/Installing the Joystick Repositioning the JoystickRepositioning the Joystick Connecting Disconnecting/Connecting the JoystickDisconnecting Disconnecting/Connecting the Joystick Accessories AccessoriesInstalling/Removing the Crutch/Cane Holder Installing/Removing the Oxygen Holder CylinderUsing the Walker Holder Installing/Removing/Using the Walker HolderInstalling/Removing the Walker Holder Global Limited Warranty Excluding Canada Global Limited Warranty Excluding CanadaCanada Limited Warranty USA