Invacare 1143206 manual Replacing Heel Loops, Model PH904A and PHAL4A

SECTION 10—FRONT RIGGINGS

Model PH904A and PHAL4A

NOTE: For this procedure, refer to FIGURE 10.3.

NOTE: PH904A style front rigging shown. PHAL4A front rigging adjust the same way.

1.Loosen, but do not remove the lug bolt and locknut that secure the lower footrest to the footrest support.

2.Reposition the lower footrest to the desired height.

3.Securely tighten the lug bolt and locknut that secure the lower footrest to the footrest support.

4.Repeat STEPS 1‐3 for the opposite side of the wheelchair footrest, if necessary.

Footrest

Support

Lug Bolt Locknut

Lower

Footrest

FIGURE 10.3 Adjusting Footrest Height -

Model PH904A and PHAL4A

Replacing Heel Loops

NOTE: For this procedure, refer to FIGURE 10.4.

1.Note the position of hex bolt, coved washers and locknut for reinstallation.

2.Remove the hex bolt, coved washers and locknut that secure the lower footrest to the footrest support.

3.Remove the lower footrest.

4.Remove the phillips® bolt, spacer and locknut that secure the existing heel loop to the lower footrest.

5.Slide the existing heel loop off the lower footrest.

6.Replace heel loop.

7.Reverse STEPS 1‐6 to reassemble.

Locknut	Coved
	Washer
Coved	Hex Bolt
Washer
Footrest	Phillips
	Bolt
Support	Spacer
Lower	Heel Loop
Footrest
	Locknut

FIGURE 10.4 Replacing Heel Loops

NOTE: When securing heel loop to lower footrest, tighten the phillips screw and locknut until the spacer is secure.

Pronto® M41 with SureStep® 46 Part No. 1143206