Invacare 1143206 manual Label Location, Positive +

Page 8

LABEL LOCATION

LABEL LOCATION

The POSITIVE ( + ) RED Battery Cable MUST connect to the POSITIVE (+) Battery Terminal(s)/ Post(s). The NEGATIVE (-) BLACK Battery Cable MUST connect to the NEGATIVE (-) Battery Terminal(s)/Post(s). DO NOT allow Battery Cable(s) to contact the opposite Battery Terminal(s)/Post(s). Install protective caps on POSITIVE (+) and NEGATIVE (-) battery terminals. Replace cable(s) immediately if cable(s) insulation becomes damaged. Failure to observe these warnings may result in an electrical short with serious personal injury and/or damage to the electrical system. See Owner’s Manual. DO NOT remove fuse or mounting hardware from POSITIVE (+) RED battery cable mounting screw. DO NOT REMOVE THIS LABEL.

BLACK

 

RED Battery

 

Washer

RED Battery

 

L-Bracket

 

Cable

Battery

 

Cable

 

 

 

 

Insulator

Cable

 

 

POSITIVE (+)

 

 

 

Nut

RED

 

FUSE

Battery

 

 

 

DO NOT

 

Terminal

 

Battery

 

 

 

Cable

 

BLACK

 

 

REMOVE

 

 

Battery

 

Washer

75 AMP

 

 

Cable

Nut

FS-HVBF Fuse

LEFT U-1

 

RIGHT U-1

Mounting Screw

FUSE

 

 

 

 

BATTERY

BATTERY

 

P/N 1143237 Rev A 8/2/06

 

 

1143237 located on underside of shroud

Weight Capacity Label located here

Serial number label is

located here

Pronto® M41 with SureStep®

8

Part No. 1143206

Image 8
Contents Pronto M41 With SureStep Accessories Warning Reference DocumentsTable of Contents Arms Batteries Special Notes MeaningSpecial Notes Label Location Positive +Typical Product Parameters FOLD-DOWNTypical Product Parameters FOLD-DOWN Controller Settings/Repair or Service Accessories InformationGeneral Guidelines Operation InformationGeneral Guidelines Batteries Charging BatteriesWeight Training Weight LimitationGrounding Instructions Rain TestEMI Information EMI Information Initial Setup Setup ChecklistSAFETY/HANDLING of Wheelchairs Stability and BalanceCoping With Everyday Obstacles Coping With Everyday ObstaclesPinch Points Lifting/StairwaysLifting/Stairways Transferring To and From Other Seats Transferring To and From Other SeatsReaching, Leaning and Bending Forward Reaching and Bending BackwardInspect/Adjust Initially Safety InspectionSafety Inspection Checklists Inspect/Adjust Weekly Inspect/Adjust MonthlyAll Wheelchairs Troubleshooting GuideInspect/Adjust Periodically Troubleshooting Electrical SPJ+ JoysticksInformation Gauge Display Diagnostics Turning the Power On/Off Wheelchair OperationUsing the Joystick to Drive the Wheelchair Movement ActionSpeedometer MK5 SPJ-INT Joystick Switches and IndicatorsOn/Off Button Charger/Programming Input Speed Control ButtonsJoystick Service Indicator Information Gauge DisplayRemoving/Installing the Arms ArmsAdjusting Angle Adjusting the ArmsAdjusting Width Adjusting Height Semi-Recline Seats Only Adjusting Depth Fold Down Back Seats OnlyRemoving/Installing the Seat Assembly InstallingSeat RemovingAdjusting the Back Angle Semi-Recline Back Adjusting the HeadrestReplacing the Seat Positioning Strap Back seat shownFootboard Assembly Removing/Installing the Footboard AssemblyAdjusting the Footboard Assembly AngleAdjusting the Footboard Assembly Depth DepthAdjusting the Footboard Assembly Height HeightInstalling/Removing Front Riggings Front RiggingsAdjusting Footrest Height Model PHWH93Replacing Heel Loops Model PH904A and PHAL4AAdjusting/Replacing Telescoping Front Rigging Supports Raising/Lowering Elevating Front RiggingsFront Rigging Replacing the Flat Free Tires on the Wheel Rim Removing/Installing the Top ShroudShroud and Wheels Removing/Installing the Rear Shroud Removing/Installing Casters Engaging/Disengaging Motor Release LeverAdjusting Forks Removing/Installing CastersRemoving/Installing Forks and/or Caster Assemblies Adjusting Anti-Dive SpringsRemoving/Installing the Joystick Assembly ElectronicsRemoving/Installing the Joystick Assembly Repositioning the JoystickConnecting the Joystick Disconnecting/Connecting the JoystickDisconnecting the Joystick Disconnecting/Connecting the Joystick Using the Proper Batteries BatteriesRemoving/Installing the Batteries Removing/Installing the Batteries Connecting/Disconnecting Battery Cables Connecting Battery CablesTerminal CapNOTE Handles on batteries removed for clarity Disconnecting Battery Cables Charging BatteriesBattery Charger Operation Battery Charger Operation Accessories Installing/Removing the Crutch/Cane HolderInstalling/Removing the Oxygen Holder Installing/Removing/Using the Walker Holder Installing/Removing the Walker HolderUsing the Walker Holder Installing/Removing/Using the Walker HolderPronto M41 with SureStep Global Limited Warranty Excluding Canada Canada Limited Warranty USA