SECTION
Seat |
| Joystick | Joystick |
|
| ||
| Arm | Mounting |
|
| Tube |
| |
|
|
|
Mounting Bracket and | Mounting | |
Screws | ||
Adjustment Lock Lever | ||
|
DETAIL “A” - STRAP LOCATIONS
Seat
Here
ArmJoystick
Joystick Cable
FIGURE 12.1 Removing/Installing the Joystick Assembly
Repositioning the Joystick
NOTE: For this procedure, refer to FIGURE 12.2.
NOTE: Take note of position and orientation of mounting hardware for reinstalling the joystick assembly.
1.Remove the joystick assembly from the wheelchair. Refer to Removing/Installing the Joystick Assembly on page 54.
2.Remove the three hex mounting screws, spacers and locknuts that secure the mounting bracket to the three mounting holes on the arm frame.
NOTE: The mounting bracket is mounted to the inside of the arm frame.
3.Reposition the mounting bracket on the opposite arm frame.
4.Using the three hex mounting screws, spacers and locknuts secure the mounting bracket to the three mounting holes of the arm frame.
5.If necessary, perform the following to reposition the adjustment lock:
A.Slide the adjustment lock from the mounting bracket.
B.Rotate adjustment lock 180° and slide adjustment lock over the opposite end of the mounting bracket.
6.Reinstall the joystick assembly onto the wheelchair. Refer to Removing/Installing the Joystick Assembly on page 54.
Adjustment Lock Lever | Hex Mounting Screws |
| |
Mounting Holes on Arm | Mounting Bracket |
| |
Frame |
|
Spacers |
|
Locknuts | Armrest Plate |
|
FIGURE 12.2 Repositioning the Joystick
Part No. 1143206 | 55 | Pronto® M41 with SureStep® |