GUARDS, COVERS AND V-BELTS
WARNING
NEVER operate the saw without blade guards and covers in place. DO NOT operate with the front of the blade guard raised. The blade exposure cannot exceed 180 degrees during operation. Adhere to the safety guidelines of the American
National Standards Institute (ANSI)
B7.1 and B7.5.
Figure 5. Blade Guard
CHECK the following on the"blade guard" (Figure 5):
■Ensure the capacity of the blade guard matches the diameter of your diamond blade.
■Check that the guard is bolted firmly upon the saw frame.
■Check that the spring tensioned front cover of the guard is firmly seated with the rear section of the guard, and there are no gaps. NEVER lift the blade guard while cutting.
V-belt Check
A worn or
CAUTION
NEVER attempt to check the
V-belt Alignment and Tensioning
This concrete saw is equipped with a premium
Use the following procedure to check the alignment of
1.Remove the bolts that secure the
Figure 6.V-Belt Cover
2.Check uniform parallelism (Figure 7) of
Figure 7. Pulley Alignment
3.