OPERATION
3.Place the engine Shutdown switch (next to the handle
lock), and the engine ON/OFF switch on the engine to the "ON" position. Shutting the engine off using this switch confirms that is is functioning properly.
Always use the Engine Shutdown Safety Switch located next to the handle lock to shut down the engine. Shutting the engine off using this switch confirms that is is functioning properly.
4.Place the Choke Lever (Figure 20) in the "CLOSED " position.
Figure 21. Throttle Lever
6. Grasp the starter grip (Figure 22) and slowly pull it out.The resistance becomes the hardest at a certain position, corre- spondingtothecompressionpoint.Pullthestartergripbriskly and smoothly for starting.
Figure 20. Choke Lever
CAUTION
DO NOT pull the starter rope all the way to the end. DO NOT release the starter rope after pulling. Allow it to rewind as soon as possible.
CAUTION
The engine speed has been set at the factory. Changing the governor speed could damage the blade and/or the saw.
5. Rotate the throttle lever (Figure 21) halfway between fast |
|
and slow for starting. All sawing is done at full throttle. The |
|
engine governor speed is factory set to ensure optimum | Figure 22. Starter Grip |
blade operating speeds. |
|