Hobart HBR300 instruction manual Clearing a Preset Tare, Setting Upper and Lower, Weight Limits

				Bench Receiving Scale
Clearing a Preset Tare	To clear a preset tare:
	1.	Remove product and container from scale platter. The
		preset tare weight displays.
		FUNCTION		TARE
	2.	HOLD DOWN	and PRESS		. The tare indicator
		and last digit flashes.

			ZERO
	3.	PRESS	CLEAR . The set tare value clears, 0.0 displays, and
		the tare indicator and last digit flashes.
	4.	PRESS	FUNCTION
			to return to Operator Mode.
Setting Upper and Lower	If you want the product to weigh a certain amount, you can
Weight Limits	set upper and lower limits.

By setting the upper and lower limits you indicate the maximum and minimum amount that you want the product to weigh on the scale. The Over indicator flashes while in the upper limit setting mode. The Under indicator flashes while in the lower limit setting mode.

✎

Tip

ØIf the upper limit is set to zero (0.0). The over/under mode will not work.

ØIf the upper limit is set to a smaller value than the lower limit, an error message (------E) displays. Refer to

ERROR MESSAGES.

To set weight limits:

1. PRESS	FUNCTION
	to set the lower limit. The Under indicator

and the last digit on the display flashes.

☛

Note

To set the upper limit only, PRESS	FUNCTION
	again now. The

Over indicator and the last digit on the display flashes. Go to step 6.

☛

Note

When setting the upper and lower limit values, only the flashing digit can be changed.

11