Hobart HBR300 instruction manual Using the Scale, Donõt

Page 7

Bench Receiving Scale

Using the Scale

When you are ready to use you scale do the following:

¥Supply power to your scale either by battery (4 D-cell) or a wall-mounted adapter plug.

¥Level the scale to maintain proper scale balance.

¥Adjust the Display Head for easy viewing.

					Over
					Accept
						Under
ZERO
					III
				Gross	FORTRADE
				Gross	LEGAL
TARE			Net	Wt.
		lb	Wt.		lb	kg
	kg				NET
				TARE	GROSS
		ZERO	FUNCTION		kg
		CLEAR	CAPACITY		x0.05
ON		CLEAR		/150kg
	OFF		x0.1lb
			300lb

Display

Head

Platter

Legs

Guidelines for using your scale:

DO

¥Set the scale in an area free of vibration.

¥Set the scale on a firm, level surface.

¥Operate in temperatures between -5°C and 40°C (23°F and 104°F).

¥Use soap and water solution to clean the scale.

¥Use four (4) D-cell batteries to power the scale.

DONÕT

¥Use solvents or abrasive materials to clean the scale.

¥Place the scale in direct sunlight or direct wind (heating

ducts, etc.).

3

Image 7

Contents HBR300 Bench Receiving Scale Page Table of Contents Page Introduction Verify Correctness of WeightFCC Note Look At This TipDonõt Using the ScaleSupplying Power to the Scale Leveling the Scale Adjusting the Display Head for Easy ViewingOver Indicator Illuminated Arrow IndicatesDisplay Head DisplayKeypad Operator ModeKey Function Setup ModePresetting Tare Operating in Setup ModeOperating the Scale Press Setting Upper and Lower Clearing a Preset TareWeight Limits Press Clearing Upper and Lower Limits Are Set Operating in Operator ModeUpper and Lower Weight Weighing a Product WhenCleaning Cleaning and Maintaining the ScaleWeighing in Batches Maintaining SanitizingDon’t Error Message Possible Cause Action Error MessagesAccessory Mobile Cart Page 34220 Rev. a 2/99