Hobart HBR300 instruction manual Error Messages, Error Message Possible Cause Action

Page 21

Bench Receiving Scale

Error Messages

Error Message				Possible Cause	Action

				Item on platter is too heavy.	ZERO
					Remove the item and PRESS CLEAR .

				Something is stuck between the	Remove the item stuck between the
				upper and lower platter covers,	covers or replace the upper platter
				or the upper platter cover has	cover.
				been removed.

				An item, which exceeds the scale	Remove the item.
				capacity, is on the platter.

				The platter cover is removed.	Replace the platter cover.

				Upper limit is set to a smaller	Reset the limits.
				value than the lower limit.

				Battery voltage is low.	Replace batteries. Refer to
		LOW

					POWERING THE SCALE.
					POWERING THE SCALE.

17

Image 21

Contents HBR300 Bench Receiving Scale Page Table of Contents Page Verify Correctness of Weight IntroductionFCC Note Look At This TipDonõt Using the ScaleSupplying Power to the Scale Leveling the Scale Adjusting the Display Head for Easy ViewingDisplay Head Indicator Illuminated Arrow IndicatesDisplay OverKeypad Operator ModeKey Function Setup ModeOperating in Setup Mode Presetting TareOperating the Scale Press Clearing a Preset Tare Setting Upper and LowerWeight Limits Press Clearing Upper and Lower Upper and Lower Weight Operating in Operator ModeWeighing a Product When Limits Are SetCleaning and Maintaining the Scale CleaningWeighing in Batches Sanitizing MaintainingDon’t Error Message Possible Cause Action Error MessagesAccessory Mobile Cart Page 34220 Rev. a 2/99