Hobart HBR300 instruction manual Supplying Power to the Scale

Page 8

Bench Receiving Scale

Supplying Power to the Scale

Power can be supplied to the scale through the AC adapter or optional batteries. The scale uses four (4) D-cell batteries not supplied by Hobart.

To insert batteries:

1.Open the front cover of the display by pulling the tab (located on the back right side of the display) toward you.

Tab

Mating

Terminal

2.Insert batteries using the imprinted diagram inside the battery case located on the inside front cover of the display head.

To use the power supply:

1.Connect the wall-mount adapter plug to a 120 V, 60 Hz, 1 Ph electrical outlet.

2.Connect the small, round 12V DC connector to the Mating Terminal (located on the left lower back corner of the display head).

☛

Note

When the scale is turned ON, all segments of the display flash approximately 5 times. Then, zero displays and the following indicators illuminate.

¥Zero

¥Stable

¥kg -- OR -- lb

¥Gross Wt.

4

Page 7 Page 9
Image 8
Page 7 Page 9
Contents HBR300 Bench Receiving Scale Page Table of Contents Page FCC Note Verify Correctness of Weight Introduction Tip Look At ThisUsing the Scale DonõtSupplying Power to the Scale Adjusting the Display Head for Easy Viewing Leveling the ScaleIndicator Illuminated Arrow Indicates Display HeadDisplay OverOperator Mode KeypadSetup Mode Key FunctionOperating the Scale Operating in Setup ModePresetting Tare Press Weight Limits Clearing a Preset TareSetting Upper and Lower Press Clearing Upper and Lower Operating in Operator Mode Upper and Lower WeightWeighing a Product When Limits Are SetWeighing in Batches Cleaning and Maintaining the ScaleCleaning Don’t SanitizingMaintaining Error Messages Error Message Possible Cause ActionAccessory Mobile Cart Page 34220 Rev. a 2/99
Top Page Image Contents